Use - Parkside PDMS 6.3 A1 Originalbetriebsanleitung

■ You must be aware that there
is a danger of mismatching
between the shaft diameter of
the small grinding tool and of
the chuck.

Use

NOTE
► The grinder may only be
operated using cleaned,
oil-atomised compressed
air and may not exceed
the maximum operating
pressure of 6.3 bar on the
appliance. The compressor
must be fitted with a pres-
sure reducer to regulate the
working pressure.
► Wind the supplied Teflon
tape around all threaded
connectors.
♦ First, screw the 1/4" threaded
nipple onto the 1/4"
threaded connector
mini compressed-air oiler
♦ Then fill the mini com-
pressed-air oiler
1–2 drops of special
compressed-air oil. To do
this, loosen the screws on the
attached Phillips screw of the
PDMS 6.3 A1
►
NOTE
►
♦
of the
.
♦
with
oil filling opening
mini compressed-air oiler
Drip a little oil into the oil filler
opening using the supplied oil
bottle .
WARNING!
Avoid eye and skin contact
with lubricants.
A mist oiler continuously
and optimally lubricates the
grinder as a preparation
stage after the pressure re-
ducer. A mist oiler adds fine
drops of oil to air flowing
through the appliance and
therefore guarantees regular
lubrication.
Now screw the 1/4" thread-
ed connector
female thread connector
of the mini compressed-air
oiler .
Now press the quick coupling
of the compressed-air hose
(not supplied) onto the com-
pressed-air connector
The connection locks auto-
matically.
GB │ IE
of the
.
into the 1/4"
.
│
35 ■