General Safety Instructions For Compressed Air Tools - Parkside PDMS 6.3 A1 Originalbetriebsanleitung

WARNING!
► The noise emission levels
specified in these instructions
have been measured in
accordance with the stan-
dardised measuring proce-
dure specified in ISO 15744
and can be used to make
equipment comparisons. The
noise emission values vary
in accordance with the use
of the compressed-air tool
and may be higher than
the values specified in these
instructions in some cases. It
is easy to underestimate the
noise emission load if the
compressed-air tool is used
regularly in a certain manner.
│ GB │ IE
■ 26
NOTE
► For an accurate estimate
of the noise emission load
during a certain working pe-
riod, the times during which
the appliance is switched off
or is running but not actually
being used must also be
taken into consideration.
This can significantly reduce
the noise emission load over
the total working period.
General safety
instructions for
compressed
air tools
WARNING!
► For multiple hazards: Please
ensure that you have read
and understood the safety
instructions before adjust-
ing, operating, repairing,
maintaining or replacement
of accessories on the mini
die grinder as well as before
working in the vicinity of the
machine. Failure to do this
can result in serious bodily
injury.
PDMS 6.3 A1