Hazards Caused By Accessories - Parkside PDMS 6.3 A1 Originalbetriebsanleitung

■ Ensure that the maximum
permissible pressure on the
machine is not exceeded.
■ Never carry com-
pressed-air-powered machines
by the hose.
Hazards caused by
accessories
■ Disconnect the grinder for
whetstones from the pow-
er supply before fitting or
replacing the machine tools or
accessories.
■ Use only accessories and
consumables of the size and
type recommended by the
manufacturer of the grinder for
whetstones.
■ Avoid direct contact with the
machine tool during and after
use, as it may have heated up
or have become sharp.
■ The maximum operating
speed recommended by the
manufacturer of the grinder for
whetstones must be the same
or higher than the rotation-
al speed labelled on the
machine.
│ GB │ IE
■ 34
■ Never fit a grinding disc,
cutting disc or milling cutter
to a grinder for whetstones. A
shattering grinding disc can
cause serious injuries or death.
■ Do not use discs which are
damaged, cracked or could
have been dropped.
■ Only approved machine tools
with the correct shaft diameter
may be used.
■ Please note that you must
ensure that the per missible
rotational speed of small grind-
ing tools is reduced due to
raising the position of the shaft
between the end of the chuck
and the small grinding tool
(overhang). Ensure that the
minimum clamping length of
10 mm is observed
(see figure 1).
min. 10 mm
Fig. 1
PDMS 6.3 A1