Programming The Clearray (Ultraviolet); Spa Maintenance - Jacuzzi J-200 series Montageanweisung Und Bedienung Und Wartung

Programming the Clearray (Ultraviolet)

Programming the CLEARRAY System (U) or Corona Dis-
charge Ozone (O3) (where included)
Press and hold the Jets pump 1 (
at the same time for 3 seconds to enter the sanitizing system
program. The screen will display one of the two menus below:
Press
Press
or
or
If the LED screen is displaying "U" then pressing the Jets pump
1 will change the sanitizing system from "U" to "O3" and exit the
programming menu. If the LED screen is displaying "O3" then
pressing the Jets pump 1 will change the sanitizing system from
"O3" to "U" and exit the programming menu.
Note: For the O3 option the "=" disables the duration countdown
timer.
If you do not wish to change the option do not press any buttons
and after 10 seconds the display will return to the main menu.
Note: If the CLEARRAY System has been selected, when the
time allotted has expired (365 days) the display screen will
flash between the water temperature and "blb". At this time the
UV lamp bulb must be replaced, the quartz tube must be
cleaned and the duration countdown timer needs to be reset.
Resetting the duration countdown timer (CLEARRAY™
System only)
Once the duration countdown timer for the CLEARRAY System
has reached zero, you will need to reset it, replace the UV lamp
bulb and clean the quartz tube.
To reset the duration countdown timer:
Press
Press
Press and hold Jets pump 1 (
time for 3 seconds.
Press the Warmer ( ) button until the display shows "0".
If the timer has reached "0", pressing the Jets pump 1 (
ton will reset the timer to 365 days. If the timer is not at "0"
pressing the Jets pump 1 button will not reset it.
Note: If the spa power is interrupted, the duration countdown
timer is not affected. The number of days remaining is stored in
the memory and will continue to countdown once power is re-
gained.
If the duration countdown timer is not at "0" and you need to re-
set it:
A. Press and hold the Jets pump 1 and Cooler buttons at the
same time for 3 seconds.
B. Press the Warmer button to scroll to "U".
C. Press the Jets pump 1 button to switch from "U" to "O3".
) and Cooler ( ) button
1 1
Press
Press
or
or
Press
Press
1
) and Cooler ( ) at the same
1 1
1 1
C. Press and hold the Jets pump 1 and Cooler buttons at the
same time for 3 seconds.
E. Press the Warmer button to scroll to "O3".
D. Press the Jets pump 1 button to switch from "O3" to "U". The
timer has been reset to 365 days.

Spa maintenance

Proper and regular maintenance of your spa will help it retain
its beauty and performance.
I
Cleaning the filter (models J-210-J-235-J-245-J-275)
The Jacuzzi ® Premium spa is equipped with a basket and a high-
performance filter cartridge, located in the compartment on the
inner wall of the spa.
Impurities are filtered by the pump which draws water into the
basket and filter cartridge which, for best performance, must be
cleaned about once a month, depending on frequency of use of
the spa. For this purpose, proceed as follows:
A. Turn off power to spa.
B. Remove the cover, unscrew the cartridge and extract it.
C. Rinse the impurities out of the folds in the filter using pres-
surised water. Work from the top down. Repeat until all folds are
clean.
A
) but-
26
B
C