Maintenance Of Wood Parts; Replacement Of The Clearray™ Lamp - Jacuzzi City Spa Bedienung Und Wartung

Before you use the spa again, refer to the chapter on operat-
ing checks for first start-up.
In areas where temperatures only occasionally drop below 0 °C,
the spa can be left in operation, since it is equipped with an anti-
freeze protection that ensures that a minimum water temperature
is maintained (see the chapter "Setting water temperature", which
contains paragraphs on maintaining the minimum water temperature
and preventing freezing of water in the pipes - "Smart Winter" mode).
Maintenance of synthetic wood parts
Synthetic wood panels require little maintenance; use a neutral
detergent when cleaning, rinsing with clean water.
CAUTION
Do not use jets of water to clean panels as they may pen-
etrate into the spa technical compartment and cause
damage to the electrical system.
Maintenance of natural wood parts
Some of the Jacuzzi® spa covering panels and accessories are
made of natural wood, treated with advanced products which
enhance the natural beauty and ensure protection against atmos-
pheric agents.
The panels and accessories first receive a coat of stain, to give the
wood an even shade. Then two coats of synthetic oil are applied,
which give the piece a natural and particularly warm appearance.
Cleaning
Maintenance varies according to the location of the spa and/
or accessories (sheltered from or exposed to the elements).
In any case, you should periodically wash the surfaces with fresh
water and neutral detergent. Then rinse.
Do not use detergents that contain alcohol, scale-removal sub-
stances, ammonia, abrasive products or bleach.
Do not use wax or polish.
Renewal
At least once a year (or less, depending on the conditions the
wood surfaces are exposed to), do the following:
Lightly sand the surface with an abrasive sponge (or sandpa-
per, grain 320). Do not press too hard, especially near protruding
parts (corners and so on).
Remove all dust. Use a soft-bristled brush to apply a layer of
synthetic oil, first crosswise and then along the entire height of
the panel.
Do not work in direct sunlight, nor if the temperature is espe-
cially cold.
If necessary, remove any excess oil using a microfiber cloth.
Let dry for about an hour (at 20°C).
Note: tools can be washed with turpentine for subsequent reuse.
If more extensive restoration is require (for example, if the pro-
tective layer has been damaged in depth), you should thoroughly
sand the entre surface all the way down to the bare wood. Apply
a coat of stain if there are marked differences in shades. Then ap-
ply two to three coats of synthetic oil as necessary, following the
same method described for the renewal phase.
Note: make sure that, between one coat and the nest, the product
has dried completely. This normally takes 1 to 2 hours at an ambi-
ent temperature of about 20 °C).
For all special maintenance, it is advisable to contact specialized
personnel.
ATTENTION: sanding residue, tools and rags used to apply the
product may self-ignite if exposed to the air. Keep the recipi-
ents (immerged in water) in tightly closed metallic containers
and dispose of them immediately. Comply with current appli-
cable regulations.
Replacement of the ClearRay™ lamp
The Clear Ray™ filtering system uses a UV lamp.
After a year, the lamp must be replaced.
Replacement or cleaning
Contact your reseller or an authorised assistance centre.
26