Filter Cycles - Jacuzzi J-200 series Montageanweisung Und Bedienung Und Wartung

Filter cycles

I
The control system activates a programmable "standard" or "e-
conomy" skimming/heating cycle. These cycles utilize pump #1
and the filter cartridge to clean the water quickly and minimize
their "bath-tub ring" effect.
Standard heating/ filtering mode for models without cir-
culation pump
(the display shows the codes F1 to F3)
This mode is normally selected in areas with cold climates where
heating times are longer due to a lower ambient temperature.
In these modes, the low-speed pump and heater will come on
as necessary to maintain the set temperature 24 hours a day.
The low speed pump will run continuously during the filtra-
tion/heating cycles with the heater coming on as necessary to
maintain the set temperature.
Economy heating/filtering mode (all models)
(the display shows the codes F4 to F6)
This mode is normally selected in areas with cold climates where
heating times are longer due to a higher ambient temperature.
In these modes, the water temperature is regulated by the set
temperature only during a programmed filtration/heating cycle.
The heater will turn on only when there is a heat call during a
programmed filtration/heating cycle.
NOTE: These modes can be used to conserve energy while
on vacation or out of town for several weeks since heater op-
eration is minimized.
Lock Modes (L1 - L2)
These modes are designed for use during spa service or to pre-
vent unauthorized use.
Economy skimming/heating modes
I
On the control panel, simultaneously hold down both buttons ( + )
and ( - ) and release.
Press either button ( + ) or ( - ) to select respectively the filter-
ing/heating mode or lock modes L1-L2 described below:
- filtering mode for models without circulation pump
During the filtration/heating cycle the Jets pump 1 low speed
will activate.
I
Standard heating/filtering mode(F1-F3)
(the heater is automatically activated if necessary)
F1: 4 hours of skimming/heating per day
(one 2-hour cycle every twelve hours)
F2: 6 hours of skimming/heating per day
(one 2-hour cycle every eight hours)
F3: 8 hours of skimming/heating per day
(one 2-hour cycle every six hours)
I
Economy filtering/heating modes (F4-F6)
(the heater is activated only during the filtering cycles)
F4: 4 hours of skimming/heating per day
(one 2-hour cycle every twelve hours)
F5: 6 hours of skimming/heating per day
(one 2-hour cycle every eight hours)
F6: 8 hours of skimming/heating per day
(one 2-hour cycle every six hours)
I
Lock modes (L1-L2)
L1: Full lock out (de-activates all mini-pool functions)
L2: Partial lock out
(disables the buttons for jets and light to prevent unauthorized
use of the spa). In this mode, the skimming/heating mode con-
tinues to operate as programmed. The temperature display flash-
es when this function is enabled. EXAMPLE: the "F3" skim-
ming/heater cycle was enabled prior to choosing lock mode.
The mini-pool continues to perform the "F3" cycle until lock
mode is cancelled, allowing another cycle to be selected.
NOTE: To exit a Lock Mode you will need to re-enter the fil-
tration/heating modes and select a cycle from F1-F6.
I
To set the time of the first skimming/heating cycle (after pur-
chase of the spa) connect the spa to the power supply two min-
utes before the desired time.
EXAMPLE: If you desire your first filtering/heater cycle to begin at
10:00 AM turn off the spa and turn it back on again at 9:58 AM.
25