Checking The V-Belts; Tensioning The V-Belts - Parkside PTBM 500 C3 Originalbetriebsanleitung

GB
Spindle-side drive
pulley (
A B C D
K L M N
U V W X
Pos.
1. D - I
2. D - I I
3. C - I
6. Slide the motor unit (13) back to tensi-
on the V-belts (29) again.
7. The V-belts (29) are correctly tensioned
when they give way slightly when
pressed.
8. Tighten the retaining bolts (12) on the
motor unit (13) again.
9. Close the gear cover (3). Fasten the
locking bolt (11) on the gear cover .
The gear cover (3) is equipped with
a interlock switch (32). If the gear
cover (3) is not closed correctly, the
device cannot be switched on.
Recommended speeds for
different drill sizes and materials:
[mm]
< 3
3 - 4
5
6 - 8
> 8
1 2
30)
E F G H I
A
O P Q R S
B
Y Z
C
D
speed
[1/min]
5 0 0 4.
6 8 0 5.
7 7 0 6.
[mm] [1/min]
< 4
2500
5 - 6 1600
7 - 8 1100
9 - 10 830
> 10
500
J A B
I
T K L
II
U V
III
speed
Pos.
[1/min]
D - I I I 8 3 0
B - I 9 8 0
C - I I 1 1 0 0

Checking the V-belts

1. Release the locking bolt (11) on the
gear cover (3).
2. Open the gear cover (3).
3. Check the tension of the V-belts (29).
4. The V-belts (29) are correctly tensioned
when they give way slightly when pressed.
5. Check the V-belts (29) for tears, cuts or
other damage.
6. Close the gear cover (3). Fasten the
locking bolt (11) on the gear cover (3).

Tensioning the V-belts

1. Release the locking bolt (11) on the
gear cover (3).
2. Open the gear cover (3).
3. Release the retaining bolts (12) on the
motor unit (13).
4. Slide the motor unit (13) back to tensi-
on the V-belts (29).
5. The V-belts (29) are correctly tensioned
when they give way slightly when
pressed.
6. Tighten the retaining bolts (12) on the
motor unit (13) again.
7. Close the gear cover (3). Fasten the
locking bolt (12) on the gear cover (3).
Motor side drive
pulley ( 31)
C D E F G
M N O P Q
W X Y Z
speed
Pos.
[1/min]
7. B - I I I 1 6 0 0
8. A - I I 2 0 0 0
9. A - I I I 2 5 0 0
H I J
R S T