Original Accessories/Attachments; Before Use; Charging The Battery Pack; Inserting/Removing The Battery Pack - Parkside PWBSA 12 A1 Originalbetriebsanleitung

Original accessories/attachments

■ Use only the additional equipment and acces­
sories specified in the operating instructions.
Using attachments or accessory tools other than
those recommended in the operating instruc­
tions can lead to a risk of injury .

Before use

Charging the battery pack

CAUTION!
► Always disconnect the mains plug before
removing or inserting the battery pack 2
from the high­speed charger 0 .
NOTE
► Never charge the battery pack at an ambient
temperature of below 10°C or above 40°C .
If a lithium­ion battery is going to be stored
for an extended period, the charge level
should be checked regularly . The optimum
charge level is between 50% and 80% . The
storage climate should be cool and dry and
the ambient temperature should be between
0°C and 50°C .
♦ Insert the battery pack 2 into the high­speed
charger 0 .
♦ Insert the power plug into the socket . The
control LED w lights up red .
♦ The green LED q indicates that the charging
process is complete and the battery pack is
ready for use .
♦ Push the battery pack 2 back into the appli­
ance .
♦ You should always switch the high­speed
charger 0 off for at least 15 minutes between
successive charging processes . Also disconnect
the power plug from the mains power socket .
■ 56 │ GB │ MT
Inserting/removing the battery
pack
Inserting the battery pack
♦ Snap the battery pack 2 into the handle 1 .
Removing the battery pack
♦ Press the two release buttons 3 and remove
the battery pack 2 .

Checking the battery charge level

♦ Press the ON/OFF switch 5 to check the
charge level of the battery . The status/
remaining charge will be shown on the battery
charge level display 4 as follows:
RED/ORANGE/GREEN = maximum charge/
performance
RED/ORANGE = medium charge/performance
RED = low charge – charge the battery

Use

Changing tools

Your tool has a fully automatic spindle lock
When the motor is stopped, the power train locks
so that the quick­release chuck 7 can be opened
by turning it . After you have attached the
desired tool and tightened it by turning the chuck
, you can continue working .
The spindle lock is released automatically when
the motor is started (by pressing the ON/OFF
switch 5) .

Select direction of rotation

WARNING!
► The rotation direction switch 6 may only be
used/adjusted when the tool is at a standstill .
♦ Select the direction of rotation by pushing the
rotation direction switch 6 to the right or left .
.
PWBSA 12 A1