Checking The Battery Charge Level; Changing Tools; Torque Selection Ring/Drill Setting; 2-Speed Gearbox - Parkside PABS 20-Li F7 Originalbetriebsanleitung

Checking the battery charge level

♦ To check the battery status, press the battery
charge level button 6 (see fig. E). The status/
remaining charge is shown on the battery
display LED 7 as follows:
GREEN/RED/ORANGE = maximum charge/
performance
RED/ORANGE = medium charge/performance
RED = low charge – charge the battery

Changing tools

Your cordless screwdriver has a fully automatic
spindle lock .
When the motor is at a standstill, the drive train is
locked so that you can open the drill chuck q by
turning it . After you have inserted the desired
tool and clamped it by turning the drill chuck
you can resume working immediately (see fig. F).
The spindle lock is released automatically when
the motor is started (by pressing the ON/OFF
switch 4).

Torque selection ring/drill setting

You can set the torque using the torque pre-
selection ring w (see fig. G).
♦ Select a low level for small screws or soft
materials.
♦ Select a high level for large screws, hard
materials or for removing screws.
♦ For drilling operations, select the drill setting
by moving the torque preselection ring w to
the position.
■ 8 │ GB │ IE

2-speed gearbox

CAUTION!
► Operate the speed selector switch 1 only
when the appliance is at a standstill. Other-
wise the appliance could be damaged.
In first gear (speed selector switch 1 in
position 1) you can reach a speed of approx.
400 rpm and a high torque. This setting is suitable
for all screw driving jobs.
In second gear (speed selector switch 1 in
position 2) you can reach a speed of approx.
1400 rpm for carrying out drilling work.

Changing the cutter knife blade

WARNING!
,
■ Wear protective gloves!
♦ Press the red button on the rear end of the
cutter knife to pull out the spare blade holder
completely.
♦ Carefully remove the worn upper blade.
♦ Slide the spare blade holder back into the
housing.
Detaching the blunt cutter
knife blade
♦ Break the blunt section of the blade off at the
defined breaking point using a pair of pliers.

Use

Switching on/off
Switching on
♦ Press and hold the ON/OFF switch 4 to start
up the appliance.
The LED work light 0 lights up when the ON/
OFF switch 4 is pressed slightly or fully,
and illuminates the working area in low light
conditions.
Switching off
♦ Release the ON/OFF switch 4 to switch off the
appliance.
PABS 20-Li F7