Herunterladen Inhalt Inhalt Diese Seite drucken

Checking The V-Belts; Tensioning The V-Belts; Adjusting The Drilling Bench; Preselecting The Drilling Depth - Parkside PTBM 500 D4 Originalbetriebsanleitung

Tischbohrmaschine
Vorschau ausblenden Andere Handbücher für PTBM 500 D4:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Checking the V-belts

1. Release the locking bolt (11) on the
gear cover (3).
2. Open the gear cover (3).
3. Check the tension of the V-belts (29).
4. The V-belts (29) are correctly tensioned
when they give way slightly when
pressed.
5. Check the V-belts (29) for tears, cuts or
other damage.
6. Close the gear cover (3). Fasten the
locking bolt (11) on the gear cover (3).

Tensioning the V-belts

1. Release the locking bolt (11) on the
gear cover (3).
2. Open the gear cover (3).
3. Release the retaining bolts (12) on the
motor unit (13).
4. Slide the motor unit (13) back to tensi-
on the V-belts (29).
5. The V-belts (29) are correctly tensioned
when they give way slightly when
pressed.
6. Tighten the retaining bolts (12) on the
motor unit (13) again.
7. Close the gear cover (3). Fasten the
locking bolt (12) on the gear cover (3).

Adjusting the Drilling Bench

1. Release the locking handle (15).
2. Push the drilling bench (20) to the desi-
red height.
3. Pivot the drilling bench (20) to the desi-
red position.
4. Fasten the drilling bench (20) again
with the locking handle (15).
5. You can also adjust the tilt angle of the
drilling bench (20). To do this, release
the retaining screw (19)
under the drilling bench (20). Tilt the
(AF 19 mm)
G B
drilling bench (20) as desired to the
right or left up to a max. of 45° and se-
cure the drilling bench (20) again with
the retaining screw (19).

Preselecting the Drilling Depth

1. Release the locking screw from the
depth stop (8).
2. Lower the drilling spindle (7) with the
mounted tool on to the workpiece.
3. Turn the scale until the silver marking
arrow attached to the motor unit (13) is
pointing to the zero line of the scale.
4. Now turn the scale to the desired
drilling depth and tighten the locking
screw (8) again.
5. Turn the drilling spindle (7) back to its
starting position.

Changing the Bit

Remove the plug from the mains
socket before changing the bit. This
will prevent an accidental start-up.
1. Fold the safety device (6) up.
2. Release the retaining jaws of the drill
chuck (4) with the drill chuck key (26)
3. Remove the bit.
4. Insert a new bit.
5. Tighten the retaining jaws of the drill
chuck (4) with the drill chuck key (26).
holder again (10).
7. Check that the bit is centred.
8. Fold the safety device (6) down again.
9. Carry out a brief trial run in order to
check the drill for true running.
Under no circumstances must you lea-
ve the drill chuck key (26) inserted.
CY
I E
N I
0
2
1 3

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis

Fehlerbehebung

loading

Diese Anleitung auch für:

290757

Inhaltsverzeichnis