Before Use; Charging The Battery Pack (See Fig. A); Inserting/Removing The Battery Pack; Checking The Battery Charge Level - Parkside PABS 20-Li D5 Originalbetriebsanleitung

Before use

Charging the battery pack (see fig. A)
CAUTION!
► Always unplug the appliance before you
remove the battery pack
to the charger.
NOTE
► Never charge the battery pack at an ambient
temperature of below 10°C or above 40°C.
If a lithium-ion battery is to be stored for an
extended period, the charge level should be
checked regularly. The optimum charge level
is between 50% and 80%. The storage climate
should be cool and dry and the ambient tem-
perature should be between 0°C and 50°C.
♦ Connect the battery pack
battery charger
♦ Insert the power plug into the socket. The control
LED lights up red to indicate that the appli-
ance is charging.
♦ The green control LED
charging process is complete and the battery
pack is ready for use.
♦ Push the battery pack
(see fig. B).

Inserting/removing the battery pack

Attaching the battery pack
♦ Move the rotation direction switch
dle position (lock, see fig. C). Slide the battery
pack into the handle until it clicks into place
(see fig. B).
Removing the battery pack
♦ Press the release button
battery pack (see fig. D).
PABS 20-Li D5
from or connect it
to the high-speed
(see fig. A).
indicates that the
into the appliance
to the mid-
and remove the

Checking the battery charge level

♦ To check the battery status, press the battery
charge level button
The status/remaining charge will be shown
on the battery display LED
GREEN/RED/ORANGE = maximum charge/
performance
RED/ORANGE = medium charge/performance
RED = low charge – charge the battery

Changing tools

Your cordless screwdriver has a fully automatic
spindle lock .
When the motor is stopped, the power train locks
so that the chuck can be opened by turning it
. After you have inserted the desired tool and
clamped it by turning the drill chuck
resume working immediately (see fig. F). The spin-
dle lock is released automatically when the motor
is started (by pressing the ON/OFF switch

Torque selection ring/drill setting

You can set the torque using the torque selection
ring (see fig. G).
♦ Select a low level for small screws or soft
materials.
♦ Select a high level for large screws, hard
materials or removing screws.
♦ Select the drill setting for drilling work by ad-
justing the torque selection ring
position (see fig. H).
(see fig. E).
as follows:
, you can
).
to the
GB │ MT │
49 ■