Program And Program Sequence Setting; Storage Program - Gram SF 930 Bedienungsanweisung

Program and
program sequence setting
The program keys
top righthand corner.
In the LED will either flash or light up continuously. (Each time the program key
is pressed the function will change).
1. Flashing LED indicates that the program has not been started. The cabinet
is ready for programming.
2. LED continuously on indicates that the program has been started.
In the LED will either flash, light up continuously or remain out. (Each
time the program key is pressed the function will change).
1. If the LED is out, the program has not been started.
2. Flashing LED indicates that the program has not been started, but the
cabinet is ready for programming.
3. LED continuously on indicates that the program has been started.

Storage program.

Program setting.
Press and the LED will flash. The actual temperature in the cabinet will be
displayed. The set temperature can be displayed by pressing one of the arrow keys.
(If a change of temperature setting is required, see section "Changing temperature
and time settings").
Program sequence.
The storage program can be started by pressing
continuously.The display shows the cabinet temperature. The set temperature can be
displayed by holding down one of the arrow keys.
(If a change of temperature setting is required, see section "Changing temperature
and time settings").
76-504-0970
contain a red LED (light emitting diode) in the
. The LED will light up
17/GB