Temperature Setting; Error Codes On The Display - Gram Gastro 07 Bedienungsanleitung

Temperature setting

Temperature control :
Temperature regulation :

Error codes on the display

Display code Description
A2 Local upper alarm LHL is or has been avtivated
A4 External upper alarm EHL is or has been activated
F1 Room sensor error. In the meantime the counter itself will maintain the
set temperature by the memory of the controller. Temperature stability
will be affected.
Service assistance is required.
F2 Evaporator sensor error. Service assistance is required.
The counter will keep running until the error has been mended.
F3* Condenser sensor error. The counter will keep running, until the error
has been mended. Service assistance is required.
F7* Indicates that the condenser temperature is too high. The cause might
be a clogged condenser, or too high ambient temperature.
If the condenser or air filter needs cleaning, the counter must be
disconnected at the mains power. Cleaning of the condenser is done
with a brush or a vacuum cleaner.
The air filter can be removed and cleaned in a dishwasher at max.
50  C.
If the ambient temperature is too high, the placement of the counter
might be wrong, and an alternative place should be found. Ventilation
might help.
If this does not help, request service assistance.
* Applies only to counters with built-in compressor.
Acknowledgement of an alarm:
Acknowledge an alarm: push
765041480
P
Press to see the cabinet temperature setting; the display will
show the set temperature.
P
Keep pressed. At the same time, press
-
+
Each time or
degree. When the display shows the desired temperature, let go of
the two keys and the setting has been made.
P
.
Rev. 000
is pressed the temperature will change one
-
+
or .
37