Combination Of Time And Temperature-Controlled Freezing Down; Changing Temperature And Time Settings - Gram SF 930 Bedienungsanweisung

The program can also be stopped by pressing
follows and the control switches over to the storage program.

Combination of time and temperature-controlled freezing down.

Program setting.
The storage program, time-controlled freezing down program and temperature-
controlled freezing down program must be set as described under the headings
above.
Program sequence.
The program is started by pressing
continuously. The order in which the programs are started is of no importance. The
display alternates every 5th second, between cabinet temperature and programmed
time.
The set temperature can be displayed by holding down one of the arrow keys and at
the same time pressing
The set time can be displayed by holding down one of the arrow keys and at the
same time pressing
(If a change of temperature or time setting is required, see section "Changing
temperature and time settings").
The program stops or can be stopped and the LED turned off in one of three ways:
1. If the set temperature has been reached before the set time has elapsed,
the temperature will be maintained until the time has elapsed. The control
then changes over to the storage program.
2. If the set temperature is not reached before the set time has elapsed,
freezing down continues until the set temperature has been reached. The
control then changes over to the storage program.
3. Each program can be stopped manually by pressing
LEDs will go out. If programs are switched off in this way, a defrost follows
and the control changes over to the storage program.
Changing temperature
and time settings
The temperature or time setting can be changed by pressing
at the same time:
76-504-0970
and
. But remember, the arrow key must be pressed first.
. But remember, the arrow key must be pressed first.
. The LED will go out. A defrost
. The LEDs will light up
P and an arrow key
or . The
19/GB