RIB KS2 Montageanweisungen Seite 21

NB: If you use too many warning lights, you risk to compromise the logic of the
control unit, possibly causing an operation block.
OPERATION WITH BLACK OUT
If a battery Is connected to the control board, the warning light indicating the battery
state turns on when the voltage is not enough, and signals that the system is operating
with the battery. Gate operation is guaranteed up to a charge level of about 10V. Beyond
this level, the charge card gives a signal to the microprocessor that stops the gate,
making blink the warning light - gate open - and the warning light - battery state -. Once
the network voltage is available again, the recharge card starts recharging the battery.
You just need to press the remote control (the opening button or the jogging operation
button) to open the gate. When the gate Is open, operate a closing command or wait
until the pause time elapses and the gate automatically closes. The gate starts from the
closing position. When It Is closed, every normal function Is ready to be activated again.
If no battery is connected to the control board, you do not need to follow any particular
procedure. When the network voltage Is available again, just press the remote control,
the opening button or the button for the jogging operation, in order to open the gate.
When the gate Is open, operate a closing command or wait until the pause time elapses
and the gate automatically closes. The gate starts from the closing position.
When the gate is closed, every normal function is ready to be activated again.
Safety devices are ready to operate during the alignment phase.
RADIO TRANSMITTER MOON
ACG6082 - 433
ACG7026 - 91
CODE LEARNIG SYSTEM RADIORECEIVERS
RX91/A quarzata and coupling
RX91/A quarzata and terminal board
RX433/A super eterodyne and coupling
RX433/A super eterodyne and terminal board
RX433/A 2CH super eterodyne, 2 channel and coupling
RX433/A 2CH super eterodyne, 2 channel and terminal board
SPARK ANTENNA
In order to make the systems mentioned above give the best performances, you need to
install an antenna tuned on the frequency of the radio receiver installed.
N.B. Pay attention not to let the central wire of the cable to came Into contact with
the external copper sheath, since this would prevent the antenna from working.
Install the antenna vertically and in such a way the remote control can reach it.
SPARK ANTENNA 91 code ACG5454
SPARK ANTENNA 433 code ACG5252
SPARK BLINKER with in-built intermittent
card code ACG7010
MECHANICAL STRIP
With double-safety contact, you can cut the length you need.
FIT SYNCRO PHOTOCELLS FOR THE WALL-INSTALLATION - code:ACG8026
The range you can set Is 30÷60ft 49÷100"
You can fit many couples close together thanks to the synchronising circuit.
Add the SYNCRO TRANSMITTER, code: ACG8028, for more than 2 photocells couples
(up to 4)
COUPLE OF BUILT-IN BOXES FOR THE FIT SYNCRO code: ACG8051
ACG6081 - 433
ACG7025 - 91
code ACG5005
code ACG5004
code ACG5055
BLOCK KEY SELECTOR FOR WALL-INSTALLATION
code ACG5056
BLOCK KEY SELECTOR TO BUILD-IN
code ACG5051
code ACG5052
L=2MT - 6,56 FEET code: ACG3010
FIT SYNCRO
BLOCK
code.:ACG1053
code.:ACG1048
Pag. 21 di 32
E
N
G
L
I
S
H