Defaults; General; Changing The Language - Fronius Testbox - Welding Torch Bedienungsanleitung

Defaults

General

To make it easier to operate the unit, the language settings can be changed immediately
after the test box is switched on.
Changing the lan-
guage
Start screen
Info about testbox
Changing the language settings
40
NOTE! Unless the 'Language' function key is pressed immediately after the unit
is switched on, the device will switch automatically to the main menu.
To change the language settings from the main menu, see the "Info about test
box" section.
Language
Info about testbox
Software
Hardware
Production date 17.05.2008
Language
1
2
3
-
4
V1.00.1
V0.2A
5
English
Connect Welding Torch test box to the
mains
Turn the mains switch to the "I" position
- The 'start screen' is displayed
Press the 'Language' function key
the 'Info about test box' screen is dis-
played
Use the adjusting dial to set the requi-
red language
Press the MENU key
- the main menu is displayed
- the selected language is now used