Assembly Appliances In Banks - Angelo Po 091FR1E Bedien- Und Installationshandbuch

ASSEMBLY APPLIANCES IN BANKS

To assemble appliances in banks (side by side)
proceed as described below.
1 - Pull off the knob (A).
2 - Undo the screws (C) and remove the control
panels (B).
3 - Apply masking tape to the edges to be placed
side by side.
4 - Apply food-approved sealant to the edges to be
placed side by side.
5 - Place the appliances side by side.
6 - Connect the appliance using the screws and
nuts (D-E).
7 - Remove the excess sealant and the masking
tape.
8 - Apply the sealant to the inside of the lid (F), and
fit it to cover the fixing zone.
9 - Replace the control panels (B) and the knobs
(A) on completion of the operation.
A variety of optional installation kits are avail-
able for arranging appliances in banks:
IT
GB
DE
FR
G
ES
ELECTRICAL CONNECTION 091FR1E - 191FR2E
Important
The connection must be made by author-
ised, skilled personnel, in accordance with
the relevant legal requirements, using ap-
propriate and specified materials.
The appliance is supplied with operating voltage 400V/
3N (230V/3 available on request) (for version 191FR2E
only), (208V/3 available on request) (for version
English
A
D
G)"Bridge" installation kit
H)Supporting frame kit
L) Supporting beam kit
H
091FR1E only)
Important
Specify the correct voltage for your device;
it cannot be modified after purchase.
Caution - warning
Before doing any work, cut off the mains elec-
tricity supply.
- 16 -
B
C
F
E
L
IDM-39614401700.tif
IDM-39614401800.tif