Practical Tips; Sanding; Selection Of Sanding Sheet; Choosing The Right Sanding Disc - Parkside PMFS 200 B2 Betriebsanleitung

Practical tips

When working with the ap-
pliance, always wear suita-
ble clothing and appropriate
protective equipment.
Prior to each use it must be
ensured that the appliance is
working correctly.
Personal protective equip-
ment and a fully functional
appliance reduce the risk of
injuries and accidents.
Always disconnect the plug from
the mains socket before working.
Danger of electric shock.

Sanding

• Move the appliance against the work-
piece once it is switched on.
• After machining, lift the sanding disc
up before turning off the device.
• Always lead the mains cable towards
the back and away from the device.
• Clean the sanding plate before you at-
tach a sanding sheet.
• Only work with sanding sheets in per-
fect condition to achieve good sanding
results.
• Work with low and even pressure and
even forward pressure. This protects
the appliance and the sanding sheet.
• Grind rough corners and edges with
the top or side edge of the sanding
sheet.
• Do not use the same sanding sheet to
sand different materials (e.g. metal
and then wood).
• Empty the dust collection box or the
vacuum cleaner regularly in order to
ensure optimal suction.

Selection of sanding sheet

When using sanding sheets without
ventilation holes, dust extraction is
not possible.
Grain size P Application
for pre-sanding rough
P 60
wood surfaces
P 80
for plain sanding
P 120
for fine sanding of primed
P 240
and painted surfaces
Choosing the right sanding
disc
Orbital sander disc:
• For sanding/grinding large surfaces
as well as corners, edges and outer
curves.
Hand sander disc:
• For processing surface areas, edges,
corners and hard to reach places.
Eccentric grinder disc:
• For fine grinding of surfaces and pro-
cessing of inner curves.
GB
13