Cautions On Installation; Cautions On Handling; Before Using - Denon AVR- 1603 Bedienungsanleitung

• We greatly appreciate your purchase of the AVR-1603.
• To be sure you take maximum advantage of all the features AVR-t603 has to offer, read these
instructions carefully and use the set properly. Be sure to keep this manual for future reference
should any questions or problems arise.
"SERIAL NO.
PLEASE RECORD UNIT SERIAL NUMBER ATTACHED TO THE REAR OF
THE CABINET FOR FUTURE REFERENCE"
• INTRODUCTION
Thank you for choosing the DENON AN Sunound receiver This remarkable component has been engineered to
provide superb surround sound listening with home theater sources such as DVD, as well as providing outstanding
high fidelity reproduction of your favorite music sources
AS this p_oduct is provided with an immense array of features, we recommend that before you begin hookup and
operation that you review the contents of this manual before proceeding
TABLE OF CONTENTS
Before Using ....................................................... 3
Cautions on Installation ....................................... 3
CauBons on Handling .......................................... 3
Features .............................................................. 3
Part Names and Functions .................................. 4
Read this First ..................................................... g
Setting up the Speaker Systems ......................... 5
Connections .................................................. 5 N 8
Using the Remote Control Unit ........................... 9
Setting up the system ................................ 9 N 12
• ACCESSORIES
Remote Control Unit ................................. 13 - I5
Opeladon .................................................. 15 - I8
Surround ................................................... 18 - 20
DSP Surround Simulation ......................... 21-23
Ustening to the Radio ............................... 23-26
Last Function Memory ...................................... 26
Initialization of the Microprocessor ................... 26
Addkional Information ................................. 27, 28
Troubleshooting ................................................ 28
Specifications .................................................... 29
List of Preset Codes ..................................... 192 - 194
Check that the following parts are included in addition to the main unit:
_ Operating instructions ................................. 1 _ R6P/AA batteries .................................... 2
Service station list .................................... 1 _ AM loop antenna ....................................... 1
Remote control unit (RC-920} ..................... I _ FM indoor antenna .................................... 1
® 14: ®
% /
[] BEFORE USING
Pay attention to the following before using this unit:
• Moving the sat
To prevent short circuits or damaged wires in the
connection cords, always unplug the power cord and
disconnect the connection cords between all other
audio components when moving the set
• Before turning the power operation switch on
Check once again that all connections are proper and
that there are not p_oblems with the connection cords
Always set the power operation switch to the
standby position before connecting and disconnecting
connection cords
• Store this instructions in a sate place.
Atter reading, store this instructions along with the
warranty in a safe place¸
• Note that the illustrations in this instructions may
differ from the actual set for explanation purposes,
• V, AUX forminal
The AVR-1603's front
panel is equipped with a
V AUX terminal¸ Remove
the cap covering the
terminal when you want
to use it
[] CAUTIONS ON INSTALLATION
Noise or disturbance of the picture may be generated
if this unit or any other electronic equipment using
microprocessors is used near a tuner or TV
If this happens, take the following steps:
• Install this unit as far as possible from the tuner or
TV
• Set the antenna wires from the tuner or TV away from
this unit's power cord and input/output connection
cords
• Noise or disturbance tends to occur particularly when
using indoor antennas or 300 _/ohms feeder wires
We recommend using outdoor antennas and 75
£3/ohms coaxial cables,
For heat dispersal, leave at least 10 cm of space
between the top, back and sides of this unit and the
wall or other components.
r_ CAUTIONS ON HANDLING
• Switching the input function when input jacks are
not connected
A clicking noise may be ploduced if the input function
is switched when nothing is connected to the input
iacks If this happens, either turn down the MASTER
VOLUME control or connect components to the input
iacks
• Muting of PRE OUT jack, HEADPHONE jack and
SPEAKER terminals
The PRE OUT iack, HEADPHONE jack and
SPEAKER terminals include a muting circuit
Because of this, the output signals are greatly
[] FEATURES
1. Dolby Pro Logic II decoder
Dolby Pro Logic [I is a new format for playing
mulfichannel audio signals that offers
_mprovements over conventional Dolby Pro Logic¸
It can be used to decode not only sources recorded
in Dolby Surround but also regular stereo sources
into five channels {front left/right, center and
surround left/right} In addition, vanous parameters
can be set according to the type of source and the
contents, so you can adiust the sound field with
greater precision¸
2. Dolby Digital decoder
Dolby Digital, a digital discrete system in which the
different channels are completely independent,
recreates "three-dimensional" sound fields (sounds
with a sense of distance, movement and position)
with no crosstalk between channels for greater
reality¸ In addition, the 5 channels (excluding the 01
channel for low frequency effects) have a playback
range extending to 20 kHz, the same as the range
of CDs, thus resulting in clearer, more richly
expressive sound¸
3. DTS (Digital Theater Systems) decoder
DTS provides up to 51 channels of wide-range, high
fidelity surround sound, from sources such as laser
disc, DVD and specially-encoded music discs¸
10 cm or mo_e
reduced for several seconds after the power
operation switch is turned on or inpot function,
surround mode or any other set-up is changed
If the volume is turned up during this time, the output
will be very high after the muting circuit stops
functioning Always wait until the muting circuit turns
off before adjusting the volume
• Whenever the power operation switch is in the
JilL OFF or STANDBY state, the apparatus is still
connected on some AC line voltages.
Please be sure to unplug the cord when you leave
home for, say, a vacation.
4. High performance DSP simulates 7 sound fields
Playback is possible in 7 sunound modes: 5-channel
Stereo, Mono Movie, Rock Arena, Jazz Club, Video
Game, Matrix and Virtual You can en}oy a variety of
sound effects for different movie scenes and
program sources even with stereo sources not in
Dolby Surround
5. Personal Memory Plus function
Personal Memory Plus is an advanced version of
Personal Memory With Personal Memory Plus, the
set automatically memorizes the surround mode,
channel volume, surround parameters, etc, for each
of the separate input sources
6. Remote control unit with pre-memory function
This unit comes with a remote control unit equipped
with a pre-memon/ function The remote control
command codes for DENON remote controllable AV
components as well as for LD players, video decks,
TVs, etc, of other major manufacturers are prestored
in the memory
7. EXT. IN jack
This unit is equipped with EXT IN jacks for use with
audio fomlats of the future
3