Denon AVR- 1603 Bedienungsanleitung Seite 20

4 _ Set the surround parameter according to the source
First, press the SURROUND PARAMETER button
NOTE: Please make sure the "AUDIO" position of the sWe switch on the remote
{Remote c o_ltrol unt) control unit
{Remote control un_tl
m
{Remote control un_tl
Use the _ (left) and _ {right) buttons to set the CINEMA EQ
(Initiall
i::::[ H ,::'_q,IR E :_:':! i:::iF:F _
{left) button (right) button
Press the SURROUND PARAMETER or _ {down) button to switch to the D
COMP setting
{Remote control un_tl
mm
{Remote control un_tl
f&
Use the _ (left) and _ {right) buttons to set the D COMP
(Initial)
(left) button (right) button
Press the SURROUND PARAMETER or _ {down) button to switch to the
LFE setting
NOTE: This parameter is not displayed during DTS playback
{Remote control un_tl
mm
{Remote control un_tl
Use the _ (left) and _ {right) buttons to set the LEE level
I
• The level can be adjusted in units of I dB from -10 to O dB
Set to the desired level according to the speaker systems being used and the
source to be played
Press the SURROUND PARAMETER or _ {down) button to switch to the
default setting
{Remote control un_tl
m_
{Remote control un_tl
To reset the settings to the factory defaults, use the _ (left) and _ (right) to
display "Yes"
(left) button (right) button
Press the SURROUND PARAMETER or _ {down) button to switch to the
CINEMA EQ setting
9
{Remote control un_tl
Press the ENTER button to finish surround parameter mode
Surround parameters _2_
CINEMA EQ. (Cinema Equalizer):
The Cinema EQ function gently decreases the leve) of the extreme high frequencies, compensating for
ovedy-bright sounding motion picture soundt(acks Select this function if the sound from the front spea(<ers
is too bright
This function only works in the Dolby Pro Logic, Dolby Digital and DTS Surround modes
D.COMP. (Dynamic Range Compression):
Motion picture soundtracks have tremendous dynamic range (the contrast between very soft and very loud
sounds) For listening late at night, or whenever the maximum sound level is lower than usual, the Dynamic
Range Compression allows you to hear all of the sounds in the soundf(ack (but with reduced dynamic (ange)
(This only works when playing program sources recorded in Dolby Digital ) Select one of the four parameters
("OFF", "LOW", "MID" (middle) or "HI" (highl) Set to OFF for normal listening
LFE (Low Frequency Effect):
Program source and adiustmenf range
1 Do(by Digital: -IO dB to O dB
2 DTS Surround: -10 dB to 0 dB
When Dolby Digital encoded software is played, it is recommended that the LFE LEVEL be set to
0 dS for correct Do(by Digital playback.
When DTS encoded _ software is played, it is recommended that the LFE LEVEL be set to
0 dS for correct DTS playback.
When DTS encoded music software is played, it is recommended that the LFE LEVEL be set to
-10 dB for correct DTS playback.
2O