Denon AVR- 1603 Bedienungsanleitung Seite 18

1 Folow step 1 to 3 under "Playing the input source" _ Star[ recording on the tape or video deck
L
For instructions, refer to the component's operating
instructions
Simultaneous recording
The signals of the source selected with the function se(ector button are output simukaneously to the
CDR/TAPE and VCR AUDIO OUT iacks If a total of two tape and/or video decks are connected and set to
the recording mode, the same source can be recorded simultaneously on every decks
NOTES:
• The AUDIO IN's signal selected with the function selector button are output to the CDR/TAPE and VCR
AUDIO OUT jacks
• The DIGITAL JN's signal selected with the function selector button are output to the DIGITAL OUT {OPTICAL)
iack
r_SURROUND
• Before playing with the surround function, be sure to use the test tones to adjust the playback level from each
speakers This adjustment can be performed from the remote control unit, as (described) below
• The adiusfment with the test tones is only effective in the DQLBY/DTS SURROUND modes
The adiusted playback levels for the different surround modes are automaticaly stored in the memory of each
surround modes
Set the DOLBY/DTS SURROUND (Dolby Pro
Logic 1 or DoIby Digital or DTS) modes
(Main unit} (Remote control _it}
T o,
1
2
Press the TEST TONE button _r_
%
(£emote control unk_
Test tones are output from the
different speakers Use the W
channel volume adjust buttons 4_ _._\
to adjust so that the volume of
the test tones is the same for
at the speakers (£emotecontrol u _it_
NOTE: Rease make sure the "AUDIO" position
of the slide switch on the remote control
unit
After completing the adjustment, press the
TEST TONE button again
%
{Remote control ur_k)
1
2, 3 _
Ee_
2
2
18
• After adjusting using the test tones, adiust the channel levels either according to the playback sources or to
suit your tastes, as (described) below
Select the speaker whose level you want to
(2? e 66o
{Main ur_k) (Remo e contro ur_]l _
The channel switches as shown below each time 2 1
the button is pressed
NOTE: P(ease make sure the "AUDIO" position
of the slide switch on the remote control
unit
Adjust the level of the selected speaker
{Main urn]t)
Only adjustable when
the channel is
selected with the CN
VOL buttons on the
ma_n unit
{Remote control urn]t)
1
Default setting of channel level is 0 dB
The level of the selected speaker can be adiusted
within theiange of +12 fo-12 dB
SW channel level can be turned off by decreasing
one step from -12 dB
OFF 44-I2 dB 44 12 dB
I°::o:o
600 loo _q_T_
1 2 4,6 5,7
Select the function to which the component you
want to play is connected
Example:
{Main unit) (Remote contro unit)
8
5,7
2
1
The Dolby Surround Pro
Logic I Cinema or Music
mode can be chosen
directly by pressing the
CINEMA or MUSIC
button on the remote
control unit during
playback in the DoIby
Surround Pro Logic 1
mode
4,6
5,7