Denon AVR- 1603 Bedienungsanleitung Seite 12

Input the type of components connected to the digital input terminals
(_ _ Use the _ (left) and _ (right) buttons to assign the input function connected
to the COAXIAL input {COAXIAL) terminal
(Initial)
[ +++ ..... +++1
(left) button {right) button
4_._ • Select "OFF" if nothing is connected
Press the ENTER or _ (down) button to switch the optical input 1 (OPT 1)
setting
' C ++ + +++ a+ + ++ + + to a ss+ + +t ++t++ co+e++
to the OPTICAL input 1 (OPT I ) terminal
(Initial)
[...."+'++ ' +'++1
{left) button {right) button
(_4_ • Select "OFF" if nothing is connected Press the ENTER or _ {down) button to switch the OPTICAL input 2 (OPT 2)
setting
C ++++ +++++ + ++ + + + + ++++++ ++e+++ ++ + ++ ,+++, '
1_2 , +,+,,+-+, +.1.+ I
(left) button (right) button
(_. • Select "OFF" if nothing is connected Press the ENTER or _ {down) button to switch the auto surround mode
setting
NOTE:
• TUNER and V AUX cannot be selected
For the three kinds of input signals as shown below, the surround mode played the last is stored in the
memory At next time it the same signal inputs, the memorized surround mode is automatically selected and
the signal is played
Note that the surround mode setting is also stored separately for the different input function
SIGNAL Default Auto Surround Mode
(i_ Analog and PCM 2-channel signals STEREO
(.2_ 2-channel signals of Dolby Digital, DTS or other multichannel format Dolby PL!I Cinema
(.3_ Mukichannel signals of Dolby Digital, DTS or other multichannel format Dolby or DTS Surround
Use the _ {left) and _ {right) buttons to select the Auto Surround mode
(Initial)
f'iL._ ] L_ ::,L_i'+:.f ':
(left) button {right) button
Press the ENTER or _ (down) button to switch the Ext In SW Level setting
Set the method of playback of the analog input signal connected to the Ext In terminal
*%
Use the _ (left) and _ (right) buttons to select the Ext In Subwoofer channel
Level playback
{Initial)
] _1 +,,ii+:,II+, I
_4 +.+.+.,...,,+ ........ . _
{left) button {right) button
Press the ENTER or _ {down) button if you want to start the settings over
from the beginning
_ Press the SYSTEM SETUP button to finish system set up
+%
This completes the system setup operations Once the System is set up, there is no need to make the settings
again unless other components or speakers are connected to or the speaker layout is changed
12