Maintenance/Cleaning; Wall Bracket - Parkside PHSL 900 A1 Originalbetriebsanleitung

• Long use of the equipment can result in
vibration-related circulatory disorders
in the hands. However, the length of
use can be extended by using suitable
gloves or taking regular breaks. Note
that a personal tendency for poor cir-
culation, low outdoor temperatures, or
high gripping forces during work will
reduce the length of use.
Maintenance/
Cleaning
Repair and servicing work not
described in this manual should
always be carried by our Service
Centre. Use only original parts.
Pull out the power plug before carry-
ing out any work on the equipment.
Wear gloves while handling the
blades.
Carry out the following maintenance and
cleaning work regularly. This will guaran-
tee a long and reliable service life.
• Before each use, check the hedge trim-
mer for obvious defects such as loose,
worn or damaged parts. Check the se-
cure seating of the bolts in the cutter bar.
• Do not use the unit if the blades are
blunt or worn. This will overstress the
motor and gearbox of the machine.
• Check coverings and safety devices
for damage and correct seating. Re-
place these where necessary.
• Keep the ventilation slots and motor
housing of the device clean. Use a
damp cloth or a brush to do this. Do
not wash down the equipment with
water, or submerge it in water.
• Do not use any cleaning agents or sol-
vents. These could cause irreparable
damage to the equipment. Chemical
substances can attack the plastic parts
of the equipment.
• Clean the cutter bar carefully after
each use. Wipe it off
with an oily cloth or
spray it with a metal
protective spray.
• Keep the hedge trim-
mer dry and covered with the blade
protection supplied and out of reach of
children.
• The gears is maintenance free

Wall bracket

You can hang the motor part on the wall
with the keyhole bore (29) on the bottom
of the device.
• Using dowels, place one screw at the
desired position on a wall.
• The screw head can have a diameter
of 7 - 10 mm.
• Leave the screw head protruding at a
distance of approx. 10 mm from the
wall.
• You can place the device onto the
screw using the opening on the bottom
and pull the device down until it stops.
When drilling, be careful not
to damage any supply lines.
Use suitable search devices
to find these or consult an in-
stallation plan for guidance.
Contact with electrical cables
can lead to electric shock and
fire. Contact with a gas pipe
can result in an explosion.
Damage to a water pipe can
lead to property damage
and electric shock.
GB
MT
33