Abicor Binzel ABITIG WH Betriebsanleitung Seite 38

9 Maintenance and cleaning
NOTE
• Only qualified personnel are permitted to perform work on the device or system.
• Check the coolant hoses, seals, and connectors for damage or leaks and replace if
necessary.
• Check and wear your personal protective equipment.
The parts of TIG welding torches listed below are subject to wear and soiling. This is why these
parts must be subjected to regular maintenance and cleaning.
1 Remove welding spatter.
2 Check all screw joints for tight fit.
ABICOR BINZEL
9.1 Sharpening the tungsten electrode
Sharpening the tungsten electrode depends on wear and must therefore be carried out when
required.
NOTE
• The length of the electrode tip should be about 1-1.5 times the electrode diameter.
Fig. 7
EN - 18
®
offers repair services at the factory.
20°
Sharpening the tungsten electrode
®
ABITIG WH
BAL.0111 • 2019-06-19