Abicor Binzel ABITIG WH Betriebsanleitung Seite 35

®
ABITIG WH
6.8 Manual torch neck change
Fig. 6
NOTE
• Do not change the hand lever position during the change procedure! This will result in
malfunctions.
1 Insert hand lever through the cover into the bore.
2 Move the hand lever forwards in the direction of the torch neck past the pressure point to the
stop and take out the torch neck.
3 Insert torch neck into changeable body as far as it will go.
4 Push the hand lever toward the rear up to the stop and take it out, after locking it.
6.9 Automatic torch neck change
The ATS rotor torch change system is a peripheral device that performs the torch neck change
during the fully automatic welding process. Request order documentation on this or consult
special documents for the exact procedure.
BAL.0111 • 2019-06-19
3.
Manual torch neck change
1.
2.
4.
6 Putting into operation
5.
EN - 15