Abicor Binzel ABITIG WH Betriebsanleitung Seite 31

®
ABITIG WH
Equip the torch neck according to the following figure:
1 Torch body
2 Gas nozzle
Fig. 2
1 Insert the electrode holder (5) into the torch body (1) from the front.
2 Insert the tungsten electrode (3) into the electrode holder (5) from the front.
3 Hold the tungsten electrode (3) and the electrode holder (5) and screw on torch cap (4).
4 Screw gas nozzle (2) onto torch body (1).
6.1.1 Equipping TIG welding torches 200WS and 400WS
1 Insert the electrode holder (5) into the torch body (1) from the front.
2 Insert the tungsten electrode (3) into the electrode holder (5) from the front.
3 Hold the tungsten electrode (3) and the electrode holder (5) and tighten the clamping
element using a torque wrench.
 Tab. 12 Tightening torques on page EN-11.
4 Screw on torch cap (4).
5 Screw gas nozzle (2) onto torch body (1).
®
ABITIG
®
ABITIG
Tab. 12
BAL.0111 • 2019-06-19
1
Step 1
5
3
4
Equipping the torch
WH 220WS
WH 400WS
Tightening torques
Step 2-3
4 3
Tungsten electrode
Torch cap
max. 1 Nm
max. 1.5 Nm
6 Putting into operation
Step 4
2
5 Electrode holder
EN - 11