Led Light Setting - Panasonic EYFLA7A Bedienungsanleitung

NOTE:
The tool ships with the buzzer mode set to
b0 by default.

LED light setting

You can select from two LED light modes.
1. Set the tool to setting configuration
mode. (See page 18.)
2. Press the B button once.
The current setting value will be displayed.
3. Press the and
desired value.
Display
d1 Linked to LED light button
d2 Linked to trigger switch operation
4. Press the OK button to accept the new
setting.
NOTE:
The tool ships with the LED light mode set
to d1 by default.
Speed control function
The speed (RPM) can be changed with the
amount of depression of the trigger.
1. Set the tool to setting configuration
mode. (See page 18.)
2. Press the B button three times.
The setting value will be displayed.
3. Press the and
desired value.
Operation
P0
P1
4. Press the OK button to accept the new
setting.
Setting the undetect time
To set the time to undetect the function of
"snug point detection level" from the start
tightening, do as follows.
1. Set the tool to the configuration mode.
(See page 18.)
2. Press button A three times.
• The current set value is displayed, and the
main unit panel starts flashing.
Display: J0 flashing.
Battery capacity indicator: The upper and
lower bars flash.
[Fig.32]
buttons to set the
Function
buttons to set the
Function
Speed control ON
Speed control OFF
3. Press and
change the time.
Operation
4. Press the OK button to accept the new
setting.
Setting the impact speed
corresponding to the length
of the socket used
(EYFLA9, EYFMA2)
To set the stable impact speed based on the
length of the socket used, do as follows:
1. Set the tool to the configuration mode.
(See page 18.)
2. Press button D three times.
• The current set value is displayed, and
the main unit panel starts flashing.
Display: h0 flashing.
Battery capacity indicator: The upper
and lower bars flash.
[Fig.33]
3. Press and
change the value.
Display
h0
h1
h2
4. Press the OK button to accept the new
setting.
Setting use interval
Use interval is set to prevent the screwdriver
from continuing its operation when the
tool is automatically stopped due to the
implementation of the torque correction
feature. This setting is valid even when the
switch is off.
1. Set the tool to the configuration mode.
(See page 18.)
- 21 -
buttons as required to
Display Seconds
30 3
1 0.1
J0 OFF
buttons as required to
Impact Speed Standard
Standard socket
(high speed)
Up to 150 mm socket
(medium speed)
Up to 250 mm socket
(low speed)
EN