Panasonic EYFLA7A Bedienungsanleitung Seite 14

Attaching or Removing Bit
EN
NOTE:
• When attaching or removing a bit,
disconnect battery pack from tool or
place the switch in the center position
(switch lock).
1. Hold the collar of quick connect chuck
and pull it out from the tool.
2. Insert the bit into the chuck. Release
the collar.
3. The collar will return to its original
position when it is released.
4. Pull the bit to make sure it does not come out.
5. To remove the bit, pull out the collar in
the same way.
CAUTION:
• If the collar does not return to its
original position or the bit comes out
when pulled on, the bit has not been
properly attached. Make sure the bit
is properly attached before use.
EYFLA7A/EYFLA7AR/EYFLA8A/EYFLA8AR
12 mm
Attaching Socket (Pin type)
Remove the socket's rubber ring and pin.
[Fig.1]
 Attach the socket to the tool.
 Insert the pin. (Taking care to align the
pin holes on the socket and tool.)
 Attach the rubber ring by sliding it into
place over the groove.
[Fig.2]
NOTE:
Be sure to attach the rubber ring to
prevent the pin from falling out.
Removing Socket (Pin type)
 Remove the rubber ring.
 Remove the pin.
 Remove the socket from the tool.
[Fig.3]
9 mm – 9.5 mm 6.35 mm
Attaching Socket (Pin-detent)
 Depress the pin-detent on the square
drive.
 Attach the socket to square drive.
 Make sure the socket is securely
attached to the square drive.
[Fig.4]
Removing Socket (Pin-detent)
 Insert a small rod into the hole on the
socket.
 Depress the pin-detent, then detach the
socket.
[Fig.5]
CAUTION:
• When attaching a socket to the driver,
verify that the socket and pin-detent do
not interfere with one another.
[Fig.6]
• Some sockets may not function well with
the driver due to their shape. Avoid use
of sockets such as the following:
 Sockets shaped so that the
pin-detent makes contact with the
side of the socket's pin hole when
the socket is attached to the driv-
er.
The pin-detent will be subjected to
excessive force, possibly damaging it.
[Fig.7]
 Sockets with a pin hole on one
side only
You may be unable to remove the
socket if it is attached in the wrong
orientation.
[Fig.8]
 Sockets whose pin holes have
beveled edges
The socket will not be held in
place with sufficient force, so that
it may come off during use.
[Fig.9]
Attaching or Removing
Bat tery Pack
1. To connect the battery pack:
- 14 -