Grinding With The Grinding Disc; Change Grinding Disc - Parkside PDOS 200 C2 Originalbetriebsanleitung

Grinding with the grinding
disc
Fold down the spark protector (1)
when grinding in order to avoid
injury from sparks.
The arrow on the protective hood
(
5) shows the direction of rota-
tion of the grinding disc.
• Place the workpiece on the workpiece
support (
11) and slowly bring it to
its desired angle on the grinding disc
(
10).
• Move the workpiece slightly from side
to side in order to achieve an optimal
grinding result. This way, the grinding
disc is worn uniformly. Occasionally,
allow the workpiece to cool down.

Change grinding disc

Information on replace-
ment:
• Never operate the device without
protective equipment.
• Ensure that the rotation speed
stated on the grinding disc (
10) is the same or higher than
the nominal rotation speed of the
device.
• Ensure that the grinding disc
dimensions match those of the
device.
• Only use lawless grinding discs
(sound test: an undamaged grind-
ing disc hanging freely on a
string will result in a clear sound
if it is tapped with a plastic ham-
mer).
• Never re-drill a locating hole
which is too small to make it
larger.
• Never use separate bushings or
adapters in order to make grind-
ing discs whose hole is too large
it the device.
• Do not use any saw blades.
• To clamp the grinding tools only
use the clamping lange provided.
The pads between the clamping
lange and the grinding tools must
be made of elastic materials e.g.,
rubber, soft cardboard etc.
• Always reassemble the device
completely after replacing the
grinding disc.
Switch the device off and remove
the mains plug.
Allow the device to cool down.
Wear protective gloves when chang-
ing the grinding discs in order to
avoid cutting damages.
The grinding disc nuts (
have different threads (left-hand
and right-hand threads). To avoid
damaging the grinding disc spindle
thread (
15), never mix up the
two grinding disc nuts (
1. Undo the ixing screws (
remove the left-hand and right-
hand grinding disc cover (
2. Unscrew the grinding disc nuts
(10a) by counter-holding the nut
on the opposite grinding disc with
a spanner (size 19 mm).
Unscrewing the left-hand nut (left-
hand thread): turn clockwise.
Unscrewing the right-hand nut
(right-hand thread):
turn anticlockwise.
GB MT
10a)
10a).
7) and
8).
43