Assembly; Assemble/Adjust Spark Protection; Assemble/Set Workpiece Supports - Parkside PDOS 200 C2 Originalbetriebsanleitung

injuries, we recommend that persons
with medical implants consult their
doctor and the manufacturer of their
medical implant before operating
the machine.

Assembly

Caution! Risk of injury!
- Ensure that you have suficient
space in which to work, and that
you do not endanger other people.
- Always fasten the device on to
the work surface with screws
featuring the suficient length and
thickness in order to maintain
control of the device.
- All covers and protective devices
must be assembled properly be-
fore commissioning.
- Disconnect the mains plug before
changing the setting on the de-
vice.
Figure and Figure
how to it the spark protection and
workpiece support on the left-hand
side of the device. Fit the second
spark protection and the second
workpiece support
Assemble/adjust spark
protection
You will need a screwdriver and a
spanner (size 8 mm) (sold separate-
ly) to use as a counter holder to it
the above.
1. Screw the spark protection (1) to
the spark protection holder (2). To
do this, use the ixing screws (4),
nut (4a), spring washer (4b) and
washer (4c) supplied.
show
Assemble/set workpiece sup-
ports
2. Fit the second spark protection in
a similar manner.
3. Screw the spark protection holder
(2) irmly to the protective hood
(5). To do this, use 1 adjusting
screw (3) including the spring
washer and lat washer and 1 nut
(3a) for each.
4. Adjust the spark protection (1)
with the adjusting screw (3) - the
distance between the grinding
disc (10) and the spark protection
must be max. 2 mm (see small
image).
Periodically readjust the spark pro-
tection in order to offset the wear
and tear of the grinding disc (dis-
tance max. 2 mm).
Despite the spark protection, you
should always wear safety glasses
when working in order to avoid eye
injuries.
1. Screw the workpiece supports
(11) on to the device.
2. To do this, use the screw (12a),
washer (12b), toothed washer
(12c) and star nut (12) supplied.
3. Set the workpiece support (11) of
the grinding disc with the star grip
nut (12) so that the distance be-
tween the grinding disc (10) and
the workpiece support is max. 2
mm (see small image).
Periodically readjust the workpiece
support in order to offset the wear
and tear of the grinding disc (dis-
tance max. 2 mm).
GB MT
41