Changing Tools; Speed Preset / Drilling Stage; Gear Drive; Operation - Parkside PABS 20-Li A1 Bedienungs- Und Sicherheitshinweise

Changing tools

Your cordless drill has a fully automatic spindle
lock .
Once the motor has come to a halt, the drive shaft
is automatically locked, so that the drill chuck
can be opened simply by turning it
After you have inserted the required bit and fixed it
in place by turning the chuck
ately continue working. The spindle lock releases
itself automatically when the motor is started (by
operation of the ON / OFF switch

Speed preset / drilling stage

You can adjust the torque by using
selection.
S elect a low setting for small screws, soft work
material.
S elect a high setting for large screws, hard
work materials and for the extraction of screws.
F or drilling, push the selector to the setting for
drilling, in that you adjust the torque pre-selector
to the position .

2 Gear Drive

CAUTION! Move the gear selector switch
only after the device has come to a standstill.
Failure to observe this advice may result in damage
to the device.
In the first gear (Gear selector switch
in Position: 1)
A speed of up to approx. 400 rpm can be achieved
and a high torque. This setting is intended for use with
all screwing tasks and for accessories (see example
Fig. B).
In the second gear (Gear selector switch
in Position: 2)
It achieves a speed of up to approx. 1400 rpm, for
the carrying out of drilling tasks (see example Fig. A).
Switching on:
3
.
, you can immedi-
Switching off:
).
6
torque pre-
2
The ON / OFF switch
trol device. Slight pressure on the ON / OFF switch
increased pressure, the rotational speed will increase.
Note: The integrated engine brake means that the
device will come to a fast standstill.
1
1
Torque:
1

Operation

Switching ON / OFF

T o start the appliance squeeze on the ON /
OFF switch and then keep it pressed down.
6
The LED working light
or fully pressed ON /OFF switch
nates the working area in poor lighting conditions.
T o stop the appliance, release the ON / OFF
switch .
6

Setting the speed

6
will cause the rotation speed to slow down. With
6

Switching direction of rotation

T o switch the direction of rotation, push the di-
rection of rotation switch
or to the left.

Tips and Tricks

B efore you use the appliance, check to see that
the screw or drill bit is properly fitted, i.e. located
centrally in the chuck.
S crew bits are designated with their dimensions
and their shape. If you are unsure, always try
the particular screw bit out to see whether it sits
in the screw head without any free play.
S maller screws and bits in particular can be
easily damaged if you adjust the appliance with
too high a torque and / or rotation speed.
Start-up / Operation
comes on with a slightly
4
and illumi-
6
has a variable speed con-
to either the right
5
GB/IE 11