Original Ancillaries / Accessories; Start-Up; Charging The Battery Pack; Insertion / Removal Of A Battery Pack Into The Appliance - Parkside PABS 20-Li A1 Bedienungs- Und Sicherheitshinweise

General safety advice for electrical power tools / Start-up
POISONOUS DUSTS!
Harmful / noxious dusts generated from your
work represent a risk to the health of the person
operating the device and to anyone near the
work area. Wear safety glasses and a dust mask!
D o not drill any material containing
asbestos. Asbestos is a known carcinogen.
H old the electrical power tool firmly.
High reaction torques may occur momentarily
during tightening or loosening of screws.
I f the inserted tool jams, switch off the
electrical power tool immediately. Be
prepared for high reaction torques as they may
cause kickback. The inserted tool may jam if
the electrical power tool is overloaded or is
held at an angle to the workpiece.
B efore you carry out any tasks on the
device, transport or store it, make sure
that the direction of rotation switch is
in the middle position (lock). To prevent
the device from starting up unintentionally.
DANGER! Take steps to ensure that
you do not hit upon any service lines
(electricity, gas, water) when work-
ing with electrical appliances. Check, if
need be with a service line detector, before you
start to cut or bore into a surface.
Original ancillaries /
accessories
U se only the ancillaries and accessories
that are detailed in the operating
instructions. The use of ancillaries and ac-
cessories other than those recommended in the
operating instructions could lead to an increased
risk of personal injury for you.

Start-up

Charging the battery pack

CAUTION! Always ensure the plug is removed
from the mains socket before inserting a battery pack
into, or removing one from, the charging station.
10 GB/IE
N ever charge the battery pack if the ambient tem-
perature is less than 10 °C or greater than 40 °C.
1. Insert the battery pack
(see Fig. C).
13
2. Insert the mains plug into the mains socket. The
status LED will light up red. The green charging
14
status LED indicates charging has completed
15
and the battery pack
3. Slide the battery pack
N ever charge the battery pack for a second time
immediately after a fast charging process has
been completed. This can give rise to the battery
pack becoming overcharged and to a reduced
service life of the battery and charging station.
S witch the charger off for at least 15 minutes
between two successive charging procedures.
Remove the power plug from the wall socket.
Insertion / removal of a battery
pack into the appliance
Inserting the rechargeable battery pack:
Move the rotation switch
position (lock). Push the rechargeable battery
pack into the handle until it engages.
8
Removing the rechargeable battery pack:
P ress the release button
rechargeable battery pack.

Checking battery status

T o check the battery status, press the battery
LED button (refer to main diagram).
11
The three battery LEDs
and the remaining charge as follows:
GREEN / RED / ORANGE = maximum charge /
capacity
RED / ORANGE = medium charge / capacity
RED = weak charge – recharge battery
into the rapid charger
8
is ready for use.
8
into the device.
8
into the middle
5
and remove the
7
indicate the condition
12