Description Of Components; Preparation; Opening Out The Handle (Illustration A1 + E1 + B1 ) - Sabo 54-A ECONOMY Betriebsanleitung

Protective gloves must be worn at all times during maintenance and cleaning work.
Maintenance and cleaning work must only be carried out if the engine has been turned off and the spark plug
connector has been removed.
• Never remove the spark plug connector when the motor is running! Risk: Electric shock.
• If the tank has to be emptied, this should be done in the open, and with a cold engine. Take care to ensure that no fuel
is spilt.
For warranty and safety reasons, original replacement parts must be used at all times.
6

DESCRIPTION OF COMPONENTS

1 Safety control bar for engine brake
2 Vario actuation (model-dependent)
3 Drive control bar
4 Oil-refill neck with dipstick
5 Engine cover
6 Cutting height setting
7 Exhaust protection grid
8 Spark plug
9 Carrying handle
10 Air filter
11 Belt drive covers
12 Tank cap
13 Ejection flap
14 Starter cable handle
15 Starter key (model-dependent)
7

PREPARATION

GB
The following parts are included in the packaging for assembly of the mower:
• Mower with preassembled handle
• Collecting bag, collecting bag frame
• Tool bag with the following contents:
– Operator's manual with Declaration of Conformity
– Warranty conditions and Warranty card
– Various fixing parts.
In the unlikely event of a missing part, please contact your dealer.

Opening out the handle (Illustration A1 + E1 + B1 )

– Pull on the handlebar which is collapsed in a Z-shape upwards into place A1 .
When the top and bottom parts of the handlebar are on the same level, firmly tighten the handle nuts by hand E1.
–
– On the lower part of the handlebar, push the ends as far apart as necessary for the locking cams facing the inside to
lock into the respective bore holes B1 .
Three different handlebar heights can be set.
Tighten the handle nuts on both sides by hand B1 .
–
– Insert the cable into the cable guide. This prevents the cable being jammed when the handlebar is folded down E1 .
(electro-start)
– Insert the throttle cables in the cable guide and fix on the lower bar using the shorter cable ties from the tool bag.
CAUTION
When you activate the bar height adjustment, when loosening the grip nuts B1 used to secure the bar bottom to
the housing (only loosen sufficiently to ensure that the bar can be moved freely) and snapping the locking cams out
of the drilled holes on the connecting bar, it is possible that unintentional upsetting of the bar may occur. In
addition, this may result in crushed points between the bar bottom and the bar connection/housing. This may result
in a risk of injury!
8