Tyre Pressure; Changing Engine Oil - Stiga PARK COMFORT Gebrauchsanweisung

Servicing carried out at an authorised workshop
guarantees professional work using genuine spare
parts.
At each basic service and intermediate service car-
ried out at an authorised workshop, the service log
is stamped. A service log presenting these services
is a valuable document that improves the ma-
chine's second-hand value.
5.2 Preparation
All service and all maintenance must be carried out
on a stationary machine with the engine switched
off.
Prevent the machine from rolling by al-
ways applying the parking brake.
Stop the engine.
Prevent unintentional starting of the
engine by disconnecting the spark plug
cable(s) from the spark plug(s) and re-
moving the ignition key.

5.3 Tyre pressure

Adjust the air pressure in the tyres as follows:
Front: 0.6 bar (9 psi).
Rear: 0.4 bar (6 psi).

5.4 Changing engine oil

This section contains tables covering the different
engines that are included in STIGA's range. To fa-
cilitate reading, mark the data that applies to the
relevant machine/engine.
5.4.1 Change intervals
The table below states hours of operation and cal-
endar months. Carry out the relevant action at
whichever occurs first.
1st time
Machine
Comfort, Residence, Hours of operation/Cal-
Ranger, President,
Excellent (B&S)
Changing the oil
5 hours
Prestige (Kohler) Hours of operation/Cal-
Changing the oil
Ranger Svan (Honda) Hours of operation/Cal-
Changing the oil 20 hours/
1 month
Change the oil more frequently if the engine has to
operate in demanding conditions or if the ambient
temperature is high.
ENGLISH
5.4.2 Engine Oil
Use oil according to the table below.
Oil
Service class
Use oil without any additives.
Do not fill with too much oil. This can cause the
engine to overheat.
Change oil when the engine is warm.
1. Attach the clamp on the oil drainage hose. Use
2. Move the clamp up 3-4 cm on the oil drainage
3. Collect the oil in a collection vessel.
4. Hand in the oil for disposal in accordance with
5. Install the oil drainage plug and move the clamp
6. Remove the dipstick and fill with new oil.
Comfort,
Residence,
Ranger,
President
Prestige
Excellent
Ranger Svan
Then at
intervals of 7. After filling up the oil, start the engine and idle
8. Check to see if there is any oil leakage.
endar months
9. Stop the engine. Wait for 30 seconds and then
50 hours/
12 months
5.4.3 Oil filter (Excellent, Ranger Svan)
First drain the engine oil and install the oil drain-
endar months
age plug as described above. Then replace the oil
- 100 hours
filter as follows:
1. Clean the area around the filter and dismantle
endar months
100 hours/ 2. Moisten the new filter's gasket with oil.
6 months
3. Install the filter. First screw in the filter so that
4. Continue with point 7 in accordance with 5.4.2
SAE 10W-30
SJ or higher
The engine oil may be very hot if it is
drained off directly after the engine is
shut off. Therefore allow the engine to
cool a few minutes before draining the
oil.
a polygrip or similar. See fig. 16-19:Y.
hose and pull out the plug.
NOTE! Do not spill any oil on the drive belts.
local provisions.
back so that it clamps above the plug.
Oil quantity:
Machine Oil quantity, approximately
No filter
replacement
1,6 litres
1,9 litres
1,6 litres
0,9 litres
for 30 seconds.
check the oil level in accordance with 4.2.
the filter.
the gasket comes into contact with the engine.
Then screw in the filter a further 1/2-3/4 turn.
Engine Oil above.
EN
Filter replace-
ment
-
-
1,7 litres
1,05 litres
69