E N
T U R n o F F
Turn off
GENERAL
put the main switch on oFF when you finish the works.
EXTERNAL - INTERNAL CHEMICAL TANK
pull the sucking hose out of the chemical tank and hang it in a bucket with clean
water. Seal the internal/external chemical tank with a cap. Rinse everything, to
remove chemicals out off the hoses, lance and pistol.
At a change of EVERY chemical product you have
to rinse the tank again with clean water!
LANCE AND GUN
Serve the spray gun till there's no pressure any more present in the conduits.
Uncouple the lance and put it away. Close the water supply.
Roll up the high and low pressure hoses.
WATER OUTLET
See chapter - "Safety – general warnings" on page 9
PUT AWAY MACHINE
Drain off the water from the supply tank.If necessary, clean the water filter(s).
Slightly clean the cleaner with a tissue. Close the protection cover. hold the
manual and the ignition keys within arm's reach. Store the cleaner in a dry
and frost free place at a horizontal and stable subsoil. press the wheel clip
protections (brakes) on the swivel castors.
ENVIRONMENTALLY SAFE DISPOSAL OF USED FLUIDS
no fluids (anti-scale product, oil, petrol, diesel, softener, ...) may be disposed
randomly because of the environment! So make sure, if you are user, that the
applicable local guidelines for environmentally friendly disposal of these fluids
(without soil pollution) are complied.
TRANSPORT
General
1
pay attention at transport to the following:
keeps the machine as much as possible horizontal during transport, one
prevents that there leaks oil from the pump. load the machine using a lift truck,
hydraulic loading platform or a hoist.
lash the machines (if necessary) sound fixed on the loading platform.
Transportation at frost
2
Replace the water sucking hose by a short piece hose and hang it with his end
in the anti-frost, so the machine can suck the anti frost. Take the lance from the
gun and operate the machine. Spray until there comes anti-frost out of the gun.
The machine is now filled with anti-frost, stop the machine.
Tip: Because the catch of the outgoing anti-frost
water, this can be re-used afterwards.
BURNER COOLING
If the cleaner is used with hot water, it is essential to turn off the boiler and
circulate cold water until the water output has reached an ambient room
temperature, to prevent or minimize limescale deposits in the circuit.
DiBO 24