Spraying Tools; Set To Work - Dibo ECN Serie Gebrauchsanweisung

FIG.2
Injection

4.3. Spraying tools

The High pressure spray lance have been carried out with a grey handle.
Not spraying: release the lever in the handle.
Spraying: pressing the lever in the handle.
Spray security: slap the block-system out in the lever.
The machine is standard provides with a single and double spray lance.
The double spray lance has two spray pipes. Halfway the spray lance is a handle which is rotating. Turn handle
right is closed. Spray jet with highest possible adjustable pressure. There will be no sucking in of the chemicals.
Turn handle left is open. Spray jet with reduced pressure. Second jet with low pressure.
How lower the pressure, the chemicals will be sucked in.
Block-system

4.4. Set to work

Put the high pressure cleaner as much as possible in a horizontal position.
Connect the spray gun with the high pressure hose (without spray lance) to the high pressure cleaner.
Connect the high pressure cleaner electrical (plug in socket).
Turn the main switch to position 1=ON.
Aim the spray gun in to the free space and operate the spray gun until the water jet is completely deaerated (+-
30 sec.).
Turn the main switch to position 0=OFF.
Connect the spray lance to the spray gun.
Turn the main switch to position 1=ON.
Operate the spray gun and check the working pressure on the pressure gauge. Adjust if necessary the pressure
regulator for the right working pressure.
DiBO n.v. 39