Component Review; Operation; Start With Petrol Motor - Dibo PTL-S serie Originalbetriebsanleitung

E N
o p E R aT I o n
1 gas handle
2 choke handle
3 fuel tap
4 pull rope

COMPONENT REVIEW

1 M OTO R
The type of motor depends on the type of machine (see technical data). For
maintenance and service of the engine DiBo advises you to read the guide
attached with the engine. all service and maintenance are described in the
attached annex of the engine.
2 M A N O M E T E R
on the manometer one can read the pressure.
3 H I G H P R E S S U R E P U M P
The type of high pressure pump depends on the type of machine
(see "Technical data" on page 25 ).
4 F U E L TA N K
The fuel tank can become filled by removing the fuel capsule (To the left is
loose). There can be refuelled at a petrol station or with a Jerry can. Tank the
correct and pure fuel. pay attention on this especially at the use of jerrycan!
There can be used exclusively the obligatory fuel. Check the jerrycan on
clogging.

operation

2

START WITH PETROL MOTOR

1 C H O K E H A N D L E
The choke is situated under the protection cover of the engine. The choke has
2 positions:
• not choking (working position, handle up to right stop)
• Choking (handle up to the left)
Warme start / warme omgeving:
Do not choke. Choke handle stays to the right stop.
Cold start:
Choke according to the needs. Engine runs warm. Move the choke handle to
the right, as the engine gets warmer.
2 F U E L TA P
The fuel tap is situated under the protection cover of the engine. The fuel tap
has two positions:
• OFF = no fuel ( tap to the left) with gas engine close down.
• ON = fuel (tap to the right) with gas engine in operation.
DiBO 16
3
1
4