Use; Manually Adjustable Sections; Adjusting The Power Of The Gas Spring - Auping K2 type 33 Gebrauchsanweisung

4. Use

4.1 Manually adjustable sections

Raise back section
Pull the adjustment cord and lean
forward with the upper part of your
body. The back section will then move
up automatically. Release the cord
when you reach the position you want.
Lower back section
Pull the adjustment cord and lean
backwards. The back section will go
down. Release the cord when you
reach the position you want.
If necessary, you can adjust the power
of the gas spring yourself (see 4.2).
Foot end
The foot end has six adjustable
positions. Carefully pull on the handle
until the desired position is reached.
To put the foot end into a lower
position you must first pull it up as far
as it will go and then lower it again.
Head support*
The head support has five adjustable
positions. Carefully pull on the handle
until the desired position is reached.
To put the head support into a lower
position you must first pull it up as far
as it will go and then lower it again.
*Type 39 only.
GB6
4.2 Adjusting the power of the gas
spring
The power with which the back section
of the mesh base is raised and
lowered is adjustable. There are three
settings:
1. light (top hole): if you select the
'light' setting, the back section is
easiest to push flat.
2. normal (middle hole): standard
setting.
3. heavy (bottom hole): if you select
'heavy', the back section comes up
with extra force.