3. Preparing for use
3.1 Components of your mesh
base
- Auping Match mesh base.
- Electric motor with remote control.
- A box containing mattress
anchors/four cable ties.
3.2 Attachment of the handset
In order to easily
attach the handset
to the surround.
Place the clamp on
the underside of
the side panel of
the surround (see
fig. 3).
Click the handset
into the clamp.
3.3 Fitting the mattress
Put your bed in the horizontal
position. Put the mattress on the
mesh base and centre it.
Make sure that the five protruding
clip-on pins of the anchors are
pushed widthways into the mesh
(see fig. 4).
'Click' the anchors into the mesh at
the positions indicated (see fig. 5).
Make sure that the anchors
are not directly above a cross bar.
3.4 Preparing for use
Check that the mesh base can move
freely. Only adjust the mesh base
while it is in a horizontal position,
securely fixed to the supporting legs,
or to the supports provided within
fig. 3
the bed surround.
Check that the mattress is attached
to the mesh base properly.
Insert the plug into the wall socket.
The plug has a safety cut-out.
fig. 4
fig. 5
GB 5