Auping K2 type 33 Gebrauchsanweisung Seite 25

Adjusting the spring tension
1. Lift the back section half way up.
2. Unscrew the plastic notched nut
(see fig. 4).
3. Attention: support the back section
and remove the connecting pin (pay
attention to the plastic bearing
bush in the eyelet of the gas
spring).
4. Place the eyelet of the gas spring in
the required position. The top hole
towards the mesh results in the
lightest adjustment.
5. Press the connecting pin through
the lifting arm and the eyelet of the
gas spring (pay attention to
plastic bearing bush in the eyelet of
the gas spring).
6. Tighten the plastic notched nut (see
fig. 5).
fig. 4
the
fig. 5
GB7