Preparing For Use; Components Of Your Mesh Base; Installing The Electric Motor; Connecting The Head Support Motor - Auping K2 type 88 Gebrauchsanweisung

3. Preparing for use

3.1 Components of your mesh base

- Auping K2 mesh base.
- Electric motor with remote control
and safety switch.
- A box containing
anchors/four cable ties.

3.2 Installing the electric motor*

1. Pull up the red locking pin A in the
sliding covers.
2. Open the two sliding covers B on
the ends of the motor.
3. Place the motor housing on the
axles so that the brackets C and D
fit into the motor housing
(see fig. 3).
Take care! The red label must be on
the side of the head support.
4. Press the motor housing down
firmly. It must remain suspended
on the brackets.
5. Slide the sliding covers back and
press down the locking pin.
*The drive motor and head support
motor may only be installed by the
Auping specialist

3.3 Connecting the head support motor

Connect the coiled flexible cable of the
premounted head support motor to
the side of the electric motor for the
mattress back section and foot end. Lead the
cable over the cross bar of the
adjusting mechanism of the back
section, giving the cable enough play
to follow the movement of the back
section.

3.4 Attachment of the handset

•In order to easily
attach the handset
to
Auronde and Next
or
model.
•Place the clamp on
the underside of
the side panel of
the surround (see
fig. 4).
•Click the handset
into the clamp.
fig. 3
the Auping
other bed
fig. 4
GB5