Maintenance And Storage - Parkside PRMA 40-Li A1 Originalbetriebsanleitung

GB
- if the apparatus starts to vi-
brate excessively, an immedi-
ate check is required.
- make sure that all nuts, bolts
and screws are properly tight-
ened.
- inspect the apparatus for any
damage.
- have any necessary repairs
carried out on damaged
parts.
• Do not bring your feet or hands
into the vicinity of rotating parts
(or beneath them). Never stand
in front of the grass ejector
opening.
• Always pull the circuit breaker/
ignition key if:
- you leave the apparatus
unattended, before clearing
blockages,
- if you are examining, clean-
ing or working on the appa-
ratus,
- after a collision with a for-
eign object. Immediately
examine the device for dam-
age and, if necessary, have
it repaired,
- if the apparatus starts to
vibrate in an unusual way
(check immediately!).
• When starting or turning the
motor on, the lawnmower must
not be tilted, unless it is re-
quired to lift the lawnmower in
the process. In this event, tilt it
only as far as absolutely neces-
sary and lift it only on the side
facing away from the user.
10

Maintenance and Storage:

• Give the motor time to cool off
before you store the device in
an enclosed space.
• During maintenance of the cut-
ting blades, be aware of the
fact that even if the power sup-
ply is switched off, the cutting
blades can be set into motion.
• Make sure that all nuts, bolts
and screws are properly tight-
ened, and that the device is in
safe working order.
• Do not try to repair the device
by yourself unless you have
professional training. All work
not specified in these operating
instructions may only be carried
out by customer service centres
authorised by us.
• Store the device in a dry place
and out of reach of children.
• Handle your device with care.
Keep the tools sharpened and
clean in order to be able to
work better and safer. Follow
the maintenance instructions.
• Wear safety gloves when re-
placing the cutting equipment.
• Check the grass collection unit
regularly for wear and tear and
deformation. Replace worn or
damaged parts in the interests
of safety. When setting up the
blades, take care that your fin-
gers do not become caught be-
tween the rotating blades and
stationary parts of the machine.
• Ensure that only replacement
cutting tools approved by the
manufacturer are used.