Working With The Device; Cleaning/Maintenance; General Cleaning And Maintenance Work - Parkside PRMA 40-Li A1 Originalbetriebsanleitung

GB
3 LEDs illuminated (red, orange and green):
Battery charged
2 LEDs illuminated (red and orange):
Battery partially charged
1 LED illuminated (red):
Battery needs to be charged

Working with the device

Observe noise protection rules and
other local regulations.
Regular mowing stimulates the grass to an
increased leaf formation, while at the same
time killing weeds. Therefore, the lawn be-
comes denser after each mowing process,
resulting in an evenly loadable lawn.
The first cut takes place roughly in April
when the grass is about 70 - 80 mm high.
During the main growing season, the lawn
is mowed at least once a week.
• Move the device at walking speed and
in lines which should be as straight as
possible. For a flawless mowing result,
the lines should always overlap by a
few centimetres.
• Adjust the cutting height so that the de-
vice is not overloaded. If this not done,
the motor may become damaged.
• Always move across slopes crosswise.
Take special care when going back-
wards and pulling the device.
• Clean the device after each use, as
described in the section "Cleaning/
storage".
After switching off the equip-
ment, the blade continues to
turn for several seconds. Do
not touch the moving blade.
There is a risk of injury.
14

Cleaning/maintenance

Have any work that is not
described in these operating
instructions performed by an
authorised customer service
centre. Only use original
parts.
Wear gloves when handling the
blade.
Switch off the apparatus, remove
the ignition key (
for the blades to come to a stand-
still.
General cleaning and
maintenance work
Never spray down the device
with water. There is a risk of
electric shock.
• Always keep the device clean. Use a
brush or cloth for cleaning, but do not
use any cleaning agents or solvents.
• After mowing, remove any plant re-
mains that have become stuck to the
wheels, ventilation opening, ejector
opening and blade area using a piece
of wood or plastic. Do not use any
hard or sharp objects as these could
damage the device.
• Check the device before each use for
obvious defects such as loose, worn or
damaged parts. Ensure that all nuts,
bolts and screws are firmly in place.
• Check the covers and protective devic-
es for damage and correct fit. Replace
these if necessary.
10) and wait