Data.out."/"Com. Sbi" Menu; Data.out."/"Prnt.par." Menu - Sartorius Entris BCE serie Betriebsanleitung

System Settings
Parameter Setting values
LIGHT OFF
ON*
* Factory setting
7.3.6

"DATA.OUT."/"COM. SBI" Menu

Parameter Setting values
COM . OUTP . IND .NO*
IND .AFTR
AUTO .W/O
AUTO W/
STOP .AUT . OFF*
ON
AUTO .CYCL . EACH VAL*
AFTER 2
INTERV .
FORMAT 22 CHARS*
16 CHARS
EXTR .LIN .
AUTO .TAR . OFF*
ON
* Factory setting
7.3.7

"DATA.OUT."/"PRNT.PAR." Menu

Parameter Setting values
ACTIVAT . MAN . NO
MAN .AFTR*
INTERV .
AUTO .LC
FORMAT 22 CHARS*
EXTR .LIN .
PRT .INIT . OFF
ALL*
MAIN .PAR .
GLP OFF*
CAL ./ADJ .
ALWAYS
TAR ./PRT . OFF*
ON
* Factory setting
22 Entris ® BCE Operating Instructions
Explanation
Deactivates the lighting on the operating display .
Activates the lighting on the operating display .
Explanations
Activates the manual data output without stability .
Activates the manual data output after stability .
Activates the automatic data output without stability .
Activates the automatic data output after stability .
Deactivates the option to abort the automatic data output .
The automatic data output is aborted by pressing the [Print] button or a software command .
Starts the automatic data output with a cycle after each value .
Starts the automatic data output with a cycle after every 2nd value .
The output rate can be set from 0 - 9999 seconds under "INPUT/INTERV ." .
The data output provides 22 characters per line (16 characters for the measured value and
6 characters for identifiers) .
The data output provides 16 characters per line for the measured value .
The data output provides an additional line with the date, time, and weight value .
Deactivates automatic taring after data output .
The device automatically tares after data output .
Explanation
Manual without stability: The print process can be started manually at any time .
Manual after stability: After pressing the [Print] button, the print command is only executed
once stability is achieved .
The output rate can be set from 0 - 9999 seconds under "INPUT/INTERV ." .
Automatically at load change: The print process starts after every load change .
The printer output prints 22 characters per line (16 characters for the measured values and
6 characters for identifiers)
The printer output prints an additional line with the date, time, and weight value .
Deactivates the output of the application parameters .
The print command prints all parameters .
The print command only prints the main parameters .
Deactivates the GLP printout .
Activates the GLP printout for all calibration and adjustment processes .
The GLP printout is always switched on . All printouts contain a GLP header and a GLP footer .
Deactivates automatic taring after printer output .
Automatically tares the device after every printout .