Reducer; Attaching/Removing The Sanding Sheet; Rotating The Sanding Plate; Working Procedures - Parkside PAHS 12 B2 Originalbetriebsanleitung

Reducer

Connection:
♦ Attach the adapter
♦ Push the reducer
♦ Push the hose of a suitable dust extraction appli-
ance (e .g . a workshop vacuum cleaner) onto the
reducer .
Removal:
♦ Pull the hose of the vacuum cleaner off the
reducer .
♦ Remove the reducer
Attaching/removing the sanding
sheet
WARNING!
► Always disconnect the battery pack
fore carrying out any work on the appliance .
NOTE
► Before fitting a new sanding sheet, remove
any dust and dirt from the sanding plate
Attachment:
♦ You can attach the sanding sheet to the sanding
plate using the Velcro .
♦ Ensure that the extraction holes on the sanding
sheet match up with those on the sander plate
.
Removal:
♦ Simply pull the sanding sheet off the sander
plate .
■ 8 │ GB │ IE │ NI
to the adapter fitting
into the adapter .
and adapter .
be-

Rotating the sanding plate

WARNING!
► Always disconnect the battery pack
.
fore carrying out any work on the appliance .
♦ Turn the sanding plate
tion until it locks into place (see fig . A) .
Removal and surface:
The material removal rate and surface quality are
determined by the grain strength of the sandpaper .
♦ Please note that you need to use appropriate
sandpapers with different grains for working
different materials .

Working procedures

■ Switch the appliance on before applying it to
the workpiece .
■ Apply minimal pressure when working .
■ Work at a constant speed .
■ Change the sanding sheets regularly .
■ Never use the same sanding sheet for sand-
ing different materials (e .g . wood followed by
.
metal) . Optimum sanding results can only be
achieved by using clean sanding sheets .
■ Clean the sanding sheet every once in a while
using a vacuum cleaner .
■ Sand hard-to-reach places with the front or side
edge of the sanding sheet on the sanding plate
.
■ Guide the sander over the workpiece in parallel
and overlapping sanding motions .
■ After completing the task, lift the appliance
from the workpiece and then switch it off .
be-
into the required posi-
PAHS 12 B2