Cleaning The Equipment; Changing The Reel; Cleaning The Air Filter - FLORABEST BL FBS 25 A1 Originalbetriebsanleitung

G B M T
Have any work not described
in these instructions carried
out by our Grizzly service
centre.
Never use metallic threads or
saw blades. The use of such
non-original parts can cause
personal injury and irrepara-
ble damage to the equipment
and will result in immediate
invalidation of the guaran-
tee.

Cleaning the Equipment

• Clean the cutting device and protective
cover of grass and earth after each cut-
ting procedure.
• Always keep the handles clean and
free of grass.
• Clean the equipment with a soft brush
or a damp cloth.
Protect the equipment from
damage!
The equipment is to be neither
sprayed with water nor placed in
water. Do not use detergents or sol-
vents. These could cause irreparable
damage to the equipment.

Changing the Reel

1. Switch off the engine.
2. Place the equipment on the
ground and ensure that no fuel
leaks and that the equipment is
safely supported.
3. Hold the spool case tightly and
unscrew the fixing screw (35)
anticlockwise
reel capsule (17) with the thread
reel (18).
6 2

Cleaning the Air Filter

. Take off
4. Place the new reel (18) in the
reel capsule (17) and push both
ends of the thread through the
thread outlet eye (36). Ensure
that the spring (37) is in the cor-
rect position.
5. Push the thread reel (18) into the
reel capsule (17) and retighten
the fixing screw (35) clockwise
.
6. Pull on both ends of the thread
to release the threads from the
grooves.
7. Trim the thread cord to approx.
13 cm in order to strain the en-
gine less in the start and warm-
up phase.
The spare parts which are to be
ordered can be found in the "Spare
parts/accessories" section
Never operate the equipment with-
out the air filter otherwise dust and
dirt enter the engine and result in
damage to the machine. Keep the
air filter clean.
1. Switch off the engine.
2. Undo the screw (38) on the air
filter cover (6) and take off the
air filter cover (6) from the air
filter housing (39).
3. Remove the air filter (40) from the
air filter housing (39).
4. Clean the filter (40) with soap
and water and allow it to dry in
the air
Never use petrol for clean-
ing!
5. Reinstall the filter (40) and the air
filter cover (6) in reverse order.