Cleaning And Maintenance; Cleaning; General Maintenance; Replacing The Cutting Insert - FLORABEST FAT 18 B3 Betriebsanleitung

Setup for edge trimming:
To trim lawn edges, slowly move the
appliance along the lawn edges.
• Handle rod: 90° (see
• Cutting angle: 90° (see
• Spacer bow in parking position
Cleaning and
maintenance
Contact our Service Centre about
repairs and servicing not described
in this manual. Only use OEM
parts. Risk of injury!
Turn off the appliance and, before
doing any servicing, remove the
battery.
The following cleaning and servicing
should be done regularly. This will ensure
a long and reliable service life.

Cleaning

Do not spray the appliance
with water and do not im-
merse it in water. Electric
shock hazard!
• Keep clean the ventilation slots, motor
housing and handles of the appliance.
Use a damp cloth or a brush.
Do not use cleaning agents or solvents.
You may otherwise irreparably dam-
age the appliance.
• After every trimming session, remove
grass and soil from the protective cover
and the trimming assembly.
• To thoroughly clean the trimming as-
sembly, remove the cutting insert
(
„
) insert") and use a sharp knife to clean
ƒ
) the pin (

General maintenance

• Prior to every use, check the appliance
for obvious defects such as loose, worn
or damaged parts.
Check that the screws in the cutting
disk are tight.
• Check covers and safety devices for
damages and correct installation. Re-
place as necessary.

Replacing the cutting insert

1. Slide the cutting insert (13) in-
2. Place the new cutting insert (13)

Storage

• Store the trimmer in a dry place well
out of reach of children.
• Do not stand the trimmer on its pro-
tective cover. Suspend it by its upper
handle in such a manner that the pro-
tective cover does not come into con-
tact with other objects. This is because
the protective cover could become
deformed, thereby changing its dimen-
sions and its safety properties.
• In order to keep the battery well
charged, avoid exposing the appli-
ance to extreme heat or cold in stor-
age.
• Remove the battery before storing the
unit for longer periods of time.
13) (see "Replacing the cutting
24).
ward and push it out of the pin
(24) on the cutting disk (12).
on the pin (24) and pull out the
insert until it snaps in.
GB
37