Vertical Cut / Lawn Edge Trimming; Cleaning.and.maintenance; Cleaning; General Maintenance - FLORABEST FAT 18 B2 Originalbetriebsanleitung

Vertical cut / lawn edge
trimming
. Be.particularly.careful.and.
attentive.when.holding.the.
cutting.disk.vertically..To.
avoid.injuries,.keep.enough.
distance.to.the.trimming.as-
sembly.
Setup.for.vertical.trimming:
Move the appliance to the right and
left in a slow swinging motion to
trim slopes and steep inclines.
• Handle rod: 180° (see
• Cutting angle: 0° (see
• Spacer bow in parking position
. Setup.for.edge.trimming:
To trim lawn edges, slowly move the
appliance along the lawn edges.
• Handle rod: 90° (see
• Cutting angle: 90° (see
• Spacer bow in parking position
Cleaning and
maintenance
Contact our Service Centre about
repairs and servicing not described
in this manual. Only use OEM
parts. Risk of injury!
Turn off the appliance and, before
doing any servicing, remove the
battery.
The following cleaning and servicing
should be done regularly. This will ensure
a long and reliable service life.

Cleaning

. Do.not.spray.the.appliance.
• Keep clean the ventilation slots, motor
housing and handles of the appliance.
Use a damp cloth or a brush.
Do not use cleaning agents or solvents.
You may otherwise irreparably dam-
age the appliance.
• After every trimming session, remove
„
) grass and soil from the protective cover
ƒ
) and the trimming assembly.
• To thoroughly clean the trimming as-
sembly, remove the cutting insert
(
insert") and use a sharp knife to clean
the pin (
„
)
ƒ

General maintenance

)
• Prior to every use, check the appliance
for obvious defects such as loose, worn
or damaged parts.
Check that the screws in the cutting
disk are tight.
• Check covers and safety devices for
damages and correct installation. Re-
place as necessary.

Replacing the cutting insert

1. Slide the cutting insert (13) in-
2. Place the new cutting insert (13)
with.water.and.do.not.im-
merse.it.in.water..Electric.
shock.hazard!
13) (see "Replacing the cutting
24).
ward and push it out of the pin
(24) on the cutting disk (12).
on the pin (24) and pull out the
insert until it snaps in.
GB
15