Assembly; Installing The Protective Cover; Fitting The Two-Part Tube - FLORABEST BL FBS 25 A1 Originalbetriebsanleitung

Start the machine only as described in
the instructions. It must not be turned
upside down or be in the working posi-
tion when it is started.
Do not cross gravel roads or paths with
the equipment running.
12. The greatest care is required when
extending the cutting thread. Risk of
injury from cuts. After executing these
processes, reassume the correct work-
ing position before switching on the
equipment.
13. Do not use metallic cutting reels or
saw blades. Note that the equipment
remains in operation for a few seconds
after the switch is released.
14. Switch off the engine when:
- Refuelling the equipment,
- Not using it,
- Leaving it unattended,
- Cleaning it,
- Transporting it from one location to
another,
- Removing or replacing the cutting
device and manually adjusting the
length of the cutting thread.
15. Length of use and breaks.
Prolonged use of the power device
can lead to problems with the blood
circulation in the hands caused by
vibrations. You can however extend
your machine use time by wearing ap-
propriate gloves or by taking regular
breaks. Please ensure that if you are
susceptible to poor circulation, low out-
side temperatures or strong gripping
forces while working, this may reduce
the length of time for which you are
able to work.
16. Carry the scythe by the multi-function
handle and the anti-vibration handle
when it is switched off, with the spool
away from your body in order to avoid
injuries.
After the device has been switched off,
the engine head of the scythe is hot.
Make sure that you do not come into
contact with the engine head.
17. You should carry out regular checks to
determine whether the cutting equip-
ment is stationary when the device is
idling.

Assembly

Installing the protective
cover
Never use the device without
the protective cover correctly
installed! Risk of injury.
1. Undo the screws (28) from the
protective cover (15) and take off
the link.
2. Position the protective cover on
the shaft holder (29).
3. Attach the protective cover again
with the help of the screws (28).

Fitting the Two-Part Tube

1. Remove the protective transport
cap (30) from the bottom shaft
tube (14).
2. Loosen the tube fixing screw (13)
on the top shaft tube (10).
3. Plug the two shaft tubes into
each other so the safety button
(31) clicks into the borehole pro-
vided for it in the top shaft tube
(10).
4. Retighten the tube fixing screws
(13) by hand.
Ensure that the bottom shaft tube is
sitting firmly and safely before start-
ing the equipment.
M T
G B
5 7