Fitting The Anti-Vibration Handle; Initial Operation; Filling With Fuel - FLORABEST BL FBS 25 A1 Originalbetriebsanleitung

G B M T
5. Dismantling:
Loosen the tube fixing screw (13). Press
the safety button (31) and pull the tubes
apart.
Fitting the anti-vibration
handle
1. Loosen the four screws (32) on
the anti-vibration handle (11).
2. Put the anti-vibration handle (11)
on the rubberised holder (33)
provided for this purpose on the
upper shaft tube (10).
3. Tighten the anti-vibration handle
(11) with the four screws (32).

Initial Operation

Warning! Before initial opera-
tion of the equipment, it must
be checked that the condition
is safe for operation. If there
is any doubt, do not start the
equipment.
Observe the following points in par-
ticular:
• Check the cutting tools for damage and
wear.
• Correct installation of the cutting head
• Easy movement of all switches
• Secure sit of the spark plug connector.
If the connector is loose, sparks can be
formed and thus ignite any leaking fuel-
air mix.
• Ensure the handles are clean in order to
be able to guide the equipment safely.
• All safety and protective devices must be
properly installed and in place before the
equipment can be started.
5 8
The cutting head must be able to run
freely.
Before starting the equipment, ensure that
the cutting head is sitting correctly and that
the moving parts are free.
Warning! If there is any doubt,
seek help with the operation
of this equipment from a spe-
cialist in an authorised service
centre.

Filling with Fuel

Always ensure good ventila-
tion when handling fuel.
Do not smoke when filling
with fuel and keep away
from any heat sources. Never
fill with fuel when the engine
is running.
Open the tank cap carefully,
so any excess pressure pre-
sent can be relieved slowly.
Start the equipment min. 3
m away from the fuel filling
location. Risk of fire or explo-
sion in case of non-obser-
vance
Use only the fuel mix recommended
in the instructions. The fuel mix ages.
Therefore, do not use fuel mix that
is older than 3 months. In case of
non-observance, the engine can be
damaged and the guarantee will be
invalidated.
The filling volume
of the tank is 650 ml.
Avoid direct skin contact with
petrol and the inhalation of
petrol fumes. Health hazard!